QT8-15 Automatic Concrete Cement Brick Machine
Features
1.The machine adopts four galvanized pipe with sleeve bearing to ensure the exact movement of mould.Concrete feeder adopts orienting way operation that will decrease the friction with mould and realize perfect concrete feeding..
2.The vibration system adopts German Frequency Conversion Technique.The vibration motor is Frequency Conversion Controlled.The lubrication of vibrator adopts oil immersed,which improve the using life of bearing and gear of vibrator.
3.Moulding is by table vibration and hydraulic pressure.Wet blocks made by our machine has good density.Solid blocks can be taken off pallet and save pallet cost.
4.The mould is made with heat treatments of quenching,tempering,carbonization and boriding.Working life of mould is improved.
5.The Electric Control System adopts Siemens PLC,Schneider contactor ,Omron proximity sensors.
Technical Parameter
Dimension |
3250x2000x2950mm |
Weight |
12T |
Pallet Size |
1150x750mm |
Power |
36.7KW |
Mode of Vibration |
Table Vibration |
Vibration Frequency |
4200r/min |
Vibration Force |
80KN |
Cycle Time |
12-16 S |
Fully Automatic Advantages:
1. Synchronous system: Main machine mould adopt compel synchronization by double-
shaft tooth. Gear and double shaft balance system can make male and female mould move stably without
any jamming phenomenon. It makes the production process more smoothly.
2. Feeding System: There is almost no power loss of gear transmission between different shafts. The concrete feeding machine is 360 degree rotating forced feeding system. It is quick speed and well distributed,
suitable for all kinds of raw materials and mould.
3. Hydraulic System: The hydraulic system adopts high and low pressure dual pump and proportional valve.
The valve can adjust flow rate and buffer cylinder. Therefore, it can protect cylinder, extend life, make
operation steadily and quickly.
4. PLC System: Our block making machine adopt Germany converter technique and intelligent control. It
makes electric motors fitting for wide voltage range. It reduced the starting current of electric motors,
saving 30% electricity than old electric motors. Moreover, the electric motors working with brake resistance
as one set, which can make the vibration system start and stop instantly. It reduce cycle time and increase
production speed.
5. Mould: It adopts special steel materials processed in two times heat treatment with carburizing technology.
Working life of the mould is greatly improved.
Contact: Helen 0086-13273138386 QQ:2362772162