Specification | CW6163 CW6263 | CW6180 CW6280 | CW61110 CW62110 | CW61125Q CW62125Q | |||
Swing over bed | 630mm | 800mm | 1100mm | 1250mm | |||
Swing over cross slide | 350mm | 480mm | 800mm | 920mm | |||
Swing over gap | 800mm | 1000mm | 1300mm | 1450mm | |||
Workpiece length | 1500 3000 5000 6000 8000 10000 12000 20000mm | ||||||
Spindle bore | 105mm (optional 130mm) | ||||||
Spindle speed and range | 7.5-1000 18kinds | 5.4-720 18kinds | 4.8-640 18kinds | ||||
Cross feed step and range | 0.05-24.3 64kinds | ||||||
Range 1:1 | 0.1-1.52 | ||||||
Range 16:1 | 1.6-24.3 | ||||||
Change gears feed range | 0.06-0.912 mm/r | 0.05-0.76 mm/r | |||||
Ratio of longitudianl feed to cross | 1/2 | ||||||
Saddle rapid speed | 4000 mm/min | ||||||
Leadscrew pitch | 12(metric) 1/2(inch) | ||||||
Metric thread | 50 kinds 1-240 (other type thread 14 kinds) | ||||||
Inch thread | 26 kinds 14-1 t.p.i | ||||||
Module thread | 53 kinds 0.5-120 | ||||||
Pitch thread | 24kinds 28-1DP | ||||||
Lower tool post travel | 420mm | 500mm | |||||
Upper tool post travel | 200mm | ||||||
Tailstock travel | 250mm | ||||||
Tailstock taper | MT6 | ||||||
Main motor | 11kw | ||||||
Loading capacity | 2000 kgs | 2000(2500) kgs | 2500 kgs | 2500(6000) kgs | |||
Bedway width | 550mm | 550(600)mm | 600mm | 600(755)mm |