1.Vibration Absorber model WDV series are designed to install in the suction and discharge lines of air condition and other refrigeration systems to reduce vibration in the transmission of compressor-induced vibration through system piping.
2.Vibration Absorber are produced by deep pitch corrugated rubbing for increasing flexibility and vibration absorption,covered by high tensile wire braid for superior strength.
3.The tubing and braid are reinforced by ferrules at each end,and connected to a female copper tube end by high temperature of brazed alloys.
4.Each vibration Adsorber is tested for pressure and then carefully vacuum tested by using a highly sensitive helium mass spectrometer leak detection device.
1.OME is available.
2.Size are available in both in metric and inch units
3.the ferrule and tube end part are made from copper
4.Hose and copper rube are brazed welded
5.All parts have been cleaned and dehydrated for refrigeration service.
6.Each pressure and vacuum unit has been tested,cleaned,dehydrated and sealed in plastic film.
7.The completed physical and chemical analysis of all basic components,
8.Components have been checked and inspected during various phases of assembly
9.Precise end sized and perfect inspection.
IMAGE: |