Product : 

folding training table

Table Size : 600 x 1800 MM

Technical Specifications for Folding Training Table

Worksurfaces

Standard worksurface tops are nominal 1 1/4" overall thickness with .030" thick high-pressure laminate top surface and .028 phenolic backer, (bottom surface). Density of the core in standard tops is 45 lb/cu ft. particleboard, M3 grade. Lightweight tops are 1 1/4" thick overall, with .040" high-pressure laminate top and .040" thick high-pressure laminate backer. Inside is a .75" thick honeycomb paper board core and M3 grade particleboard, laminated between 2 layers of 5.2mm thick plywood.

Flipping/Nesting Table Frame

The framework for table support and flipping/nesting operation consists of 1 1/2" diameter, .06" thick wall, steel tubing with 1/2" threaded inserts welded inside the tubes for mounting the legs. 4mm thick stamped steel brackets support the horizontal framework through injection molded Acetal bushings while 1/4" Phillips wood screws attach the framework brackets to the worksurface. The 3/4" diameter steel latch release handle is actuated at the center and front underside of the worksurface. Pulling forward, using one hand, raises the worksurface for nesting storage. To lower the table for use from the upright storage position, a steel locking latch is located on one support arm and must be released prior to lowering the table. All hinge pins for the flipping mechanism are zinc plated steel. Hinge pin spaces are molded nylon. The framework is shipped separately, ready to be assembled to the worksurface and legs.

Ganging Mechanism

Built of black, high-strength nylon, the hook and peg combination draws tables together. No tools are required when joining tables.  Gangers are self-storing under the table when not in use. Tops are pre-drilled for placement of ganging pegs. Two gangers, four pegs and all mounting screws are included in the kit. One kit per table joint is required.   Field installed

Wedges and Joining Mechanism

Wedges are offered in 30°, 45° and 60° wedge shapes along with a 90° “quarter round”. The wedges are sized to join all standard Hurry Up! tops, and can be used to create conference or training room table combination shapes such as squares, rectangles or hexagonal arrangements. Wedges are 45 lb./cu ft. density, M3 grade particleboard, with .030" high-pressure laminate top and .028  phenolic backer

Vertical Leg Wire Management

A black extrusion made of PVC with self-adhesive tape attaches to the Hurry Up! leg managing cables and wires exiting PowerUp® or standard grommets installed on the worksurface top. The extrusion is 3" long. The extrusion is divided into two separate cable routing areas for separating wires if required. Factory installed