Copied design at the bottom where the plastic part is connected to metal sheet with screw, bad stability as a result of poor assemble and aging of the mould!
One-piece design, improved stability!
Base is soft who can be bent easily!
More support considered in the product design who make the base much stronger!
Even though cover test is not required for this heater, a potential risk still exist!
Some customer choose thermal fuse but it is not sensitive as it always have a delay activation.
The most important is: the product will finish after it worked!
We set a thermal cut off who will close the heater when it is over-heating!
(optional with up-cost)
The heating element is connected to the ceramic holder by point contact, which is may spark and fire!
Large contacting area make the connection much safer!
Can't use on carpet!
Can be used on carpet, small change but we have considered from the view of the customer!
The construction use ceramic holder pressed by spring, the forcing bearing point is on the heating element make the halogen tube broken easier.
The forcing bearing point is on the two end of the heating element and there will have a buffer through the mica sheet!
Internal wire can be seen directly, may fail the finger test if there was faulty workmanship!
Hidden louver make the product nicer and safer!