Widely Use Professional Liquid UV Conformal Coating For PCB With Component
Description
DHE-600 conformal coating is a polyurethane modified resin paint, with transparent liquid performance.
One-part, translucent medium viscosity conformal coating with firm, abrasion resistant surface after cure.
Typical Physical Properties
Property | Unit | Value |
Typical Uncured Properties | ||
Color | / | Translucent yellow |
Tack-Free Time (23 °C, 50% RH) | min | 5~10 |
Cure Time (23 °C, 50% RH) | hr | 12 |
Viscosity (25+1℃) | mPas | 12-16 |
Density (25℃) | g/ml | 0.89±0.02 |
Solids content | / | 40%±1% |
Temperature Range | / | -50℃-200℃ |
Typical Cured Properties | ||
Volume resistivity (normal condition) | Ω - cm | 1×1015
|
Volume resistivity (dip in water) | Ω - cm | 1×1014 |
Dielectric strength (normal condition) | kv/mm | 110 |
Dielectric Strength (dip in water) | kv/mm | 102 |
Water absorption (24h, 25℃) | mg | 10 |
Water absorption (0.5h, 100℃) | mg | 5 |
Oil resistivity | / | PASS |
Vulcanization (3days, 25℃) | / | PASS |
UL Flammability Classification | NA | 94 V-0 |
*Typical physical properties are average data and should not be used as or to develop product specifications.
Processing Considerations
Surface Preparation
The cleanliness of the circuit board substrate is critical to successful application of the conformal coating and its long-term performance. Surfaces must be free of moisture, dirt, wax, grease and other contaminants. Failure to remove contamination can lead to long-term failure of the circuit assembly.
The time required to reach a tack-free state can be reduced with heat. When using heat for this purpose, allow adequate time for the solvent to evaporate prior to exposing to elevated temperatures in an air circulating oven.
Application Method
- Spray
- Brush
- Dip
- Automated pattern coating
Curing
DHE-600 conformal coating typically cures under room temperature conditions. Depending upon ambient conditions, coated circuit boards may be fully cured on 12 hours.
Product Safety, Handling and Storage
Customers should review the latest Safety Data Sheet (SDS) and label for product safety information, safe handling instructions, personal protective equipment if necessary, emergency service contact information, and any special storage conditions required for safety.
SDS are available upon request, from any DHE representative.
Special precautions must be taken to prevent moisture from contacting DHE-600 conformal coatings. Containers should be kept tightly closed and head or air space minimized. Partially filled containers should be purged with dry air or other gases, such as nitrogen.
The product should be stored in its original packaging with the cover tightly attached to avoid any contamination. Store in accordance with any special instructions listed on the product label. The product should be used by its ‘Use Before’ date as indicated on the product label.
Packing information
Iron pail: 3kg, 17kg.
*Multiple packaging sizes are available for this product.