128x128, General 1.5inch OLED display Module

Overview

This is a general OLED display Module, 1.5inch diagonal, 128x128 pixels, 16-bit grey level, with embedded controller, communicating via SPI or I2C interface.

Features

• 128x128 high resolution
• 16-bit grey level, better display effect
• Supports SPI or I2C interface, configured via onboard resistor
• Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)

Specifications

• Driver: SSD1327
• Interface: SPI / I2C
• Display color: White
• Grey level: 16-bit
• Resolution: 128x128 (most other competitive products are typically 128x64)
• Viewing angle: >160°
• Operating voltage: 3.3V / 5V
• Dimension: 44.5 x 37 (mm)

Interface

SYMBOL	DESCRIPTION
VCC	Power (3.3~5V input)
GND	Ground
DIN	Data input
CLK	Clock data input
CS	Chip selection, low active
DC	Data/Command selection (high for data, low for command)
RST	Reset, low active

There are two available drive interfaces for this OLED module: 4-wire SPI and I2C:

	BS	CS	DC	DIN	CLK
4-wire SPI	0	Chip select	Data/Command	MOSI	SCK
I2C	1	NC	I2C address selection	SDA	SCL

Dimensions

Photos

Development Resources

Wiki : www.waveshare.com/wiki/1.5inch_OLED_Module

Selection Guide

Part Number	Color	Resolution	Display Size (mmxmm)	Interfaces	Driver	Dimension (mmxmm)	Pinheader
0.91inch OLED Module	White	128x32	22.38×5.58	I2C	SSD1306	36.0x12.5	PH2.0 connector
0.95inch RGB OLED (A)	65K colorful	96x64	20.14x13.42	SPI(4-wire SPI)	SSD1331	31.7x37.0	angled/horizontal
0.95inch RGB OLED (B)	65K colorful	96x64	20.14x13.42	SPI(4-wire SPI)	SSD1331	31.7x37.0	straight/vertical
0.96inch OLED (A)	1/4 yellow section, 3/4 blue section	128x64	21.7x11.2	3-wire SPI, 4-wire SPI, I2C	SSD1306	33.0x33.5	angled/horizontal
0.96inch OLED (B)	1/4 yellow section, 3/4 blue section	128x64	21.7x11.2	3-wire SPI, 4-wire SPI, I2C	SSD1306	33.0x33.5	straight/vertical
1.3inch OLED (A)	Blue	128x64	29.42x14.7	3-wire SPI, 4-wire SPI, I2C	SH1106	40.5x37.5	angled/horizontal
1.3inch OLED (B)	Blue	128x64	29.42x14.7	3-wire SPI, 4-wire SPI, I2C	SH1106	40.5x37.5	straight/vertical
1.5inch OLED Module	White (16 gray scale)	128x128	26.86x26.86	4-wire SPI, I2C	SSD1327	44.5x37.0	PH2.0 connector
1.5inch RGB OLED Module	65K colorful	128x128	26.86x26.86	3-wire SPI, 4-wire SPI	SSD1351	44.5x37.0	PH2.0 connector

Note: the 0.96inch OLED consists of 1/4 yellow upper section and 3/4 blue lower section, not a regular dual-color display.

PACKAGE CONTENT

1. 1.5inch OLED Module x1
2. PH2.0 7Pin x1