Water Colling Automatic Tool Change 3.0kw 5.5kw 7.5kw 11kw Collet 220V-380V CNC Router spindle motor

This series of spindles are mainly used in mold processing, metal processing, stone processing, woodworking processing and other fields.

The spindle power covers3.0kw-11kw, with a maximum speed of 24,000 RPM.

This type spindle can be cooled by water or oil.

It is characterized by compact structure, light weight, low inertia, low vibration and low noise.

Product safety precautions:

• Personal safety

  1. Before starting the spindle, please keep the spindle in the state of emergency stop at any time

  2. During the operation of the spindle, please do not touch its rotating part. Take necessary protective measures to avoid the spindle directly facing the operator or other personnel.

  3. If the power supply is restored after an instantaneous power failure during operation, the spindle may suddenly start again, so do not get close to it to avoid accidents.

  4. After power is turned off, do not touch the wiring position of the power connection while the spindle is still in the state of rotation

  5. Please do not set, disassemble or repair the spindle for non-designated personnel.

• Product safety

          1.Spindle is a high speed, precise integration of mechanical and electrical components, for the correct and safe use of the spindle, please carefully read the instructions and precautions before use.

   2.The storage temperature of the motorized spindle is 20±10°C, the humidity is 85%, and the maximum storage time is three months.

   3.Before starting the spindle, first connect the coolant, during the rotation, do not allow to break the coolant, otherwise it will damage the spindle parts.

   4.Special disassembly tools should be used when removing the chuck.

   5.When installing the spindle, do not clamp the body too tightly to avoid internal parts damage caused by deformation of the body.

   6.Do not overspeed the spindle, and adjust the operating parameters according to the range in the technical parameters table.

   7.When the spindle is newly installed or has not been used for a long time, it is forbidden to run at the maximum speed of the spindle when starting up. It should run at a low speed for 5-10 minutes and then rise to the working speed.

   8.Do not disassemble and operate the spindle without training personnel.