Washing Equipment Washing Machine Industrial Commercial Hospital Factory Laundry Whole Sale Price Machine

1. The door cannot be opened after the washing cycle of the fully automatic washing machine
Possible cause of failure:
1. There is water in the outer cylinder
2, the inlet pressure is too low
3. The air pipe connected to the cylinder of the drain valve is cut off.
4. The solenoid valve that opens the drain valve is damaged.
5. Open the cylinder damage of the drain valve
6, the door is misaligned, the latch is stuck
7, can not accept any signal to open the door from the controller
Solution:
1. Check the drain valve and drain piping system and clean or repair if necessary
2. Increase the inlet air pressure to 6-7kgf/cm
3. Repair or reconnect the trachea
4. Repair or replace the solenoid valve
5. Repair or replace the cylinder that opens the drain valve
6, re-adjust the position of the door, close the door
7, replace the controller

2. The fully automatic washing machine cannot be started. When the door is closed, the display shows “door open”
Fault cause: door closing limit switch is damaged
Solution: Repair or replace the door limit switch