UV indicator Low viscosity transparent flow RTV1Silicone adhesive sealant for Shallow sealing of Network Transformer

1. Instructions

1). Surface cleaning: Cleaning the sticklied and coated surface, remove the rust, dirt and oil.

2). Brush the glue: Unscrew the hose cap (or cut open), pushed the glue to clean the surface, evenly distributed so that will be glued surfaces together and fixed.

3).Curing: put the glued or sealed parts in the air and let it be natural cured. It’s one curing process that cured from the surface to the internal, in less than 24 hours (at room temperature and 55% relative humidity) glue curing depth of 2 ~ 4mm, if the sizing location more deeper, in particular, which is not easily accessible to the air, then the fully curing time will be extended, if the temperature is low, the curing time will be extended too, sealant is fully cured at least 7 days if the thick have 6mm.

1. Note

After Operating, unused glue must be sealed and stored , and tighten the cap immediately,. if the seal has a little crust when use it in the next time, remove it and it will not affect the normal use. During the storage process, the canal orifices may appear a small amount of the curing phenomenon, cleared it and it can use it again, and no affection to the product performance.

1. Packing, Storage and transportation
2. Sample:1kg/ tank; 18kg/ bucket.
   1. 1. (which may be decided according to user's need)
3. Suggestions and statement

1, The product must be stored in a cool, dry environment below 25 ℃, can be storaged below 25 ℃ for six months.
2, Such products are non-dangerous goods, can be transported as common chemicals. Be careful during transport and prevent the leakage.
3, Should be recognized before being used with or without abnormal if the products exceeding retention period.

    This article contains a variety of data are for reference only ,and we sure that is reliable. For anyone to adopt the way in which we can't control the result, we will not be responsible for.