USA MAKE RO MEMBRANES MODEL LCLE 4040.

FILMTEC Membranes

 Large Commercial 4040 Reverse Osmosis Elements

^Features                                                                                                                                                                                     LC 4040 product range are available to meet a wide variety of customer needs in commercial applications, from producing high purity water to delivering low total system costs. Our  fully automated element production enables the most consistent products in the industry that minimizes the total cost of ownership of water treatment systems.

 ·         LC HR-4040 produces high quality water with our state of the art RO membrane.

 ·          LC LE-4040 delivers high quality water at low pressure at harsh water conditions, using Dow’s innovative, proprietary technology for     low energy applications.

Product Specifications

1.    Permeate flow and salt rejection based on the following test conditions: 2000 ppm NaCl, 77°F (25°C), 15% recovery, pH 8, and applied pressure 225 psig for LC HR and 125 psig for LC LE

2.    Permeate flows for individual elements may vary +/-15%.

3.    For the purpose of improvement, specifications may be updated periodically.

Operating Limits

a.        Maximum temperature for continuous operation above PH 10 is 95°F (35°C).

b.        Refer to Cleaning Guidelines in specification sheet 609-23010.

c.        Under certain conditions, the presence of free chlorine and other oxidizing agents will cause premature membrane failure. Since oxidation damage is not covered under warranty, Dow recommends removing residual free chlorine and other oxidants by pretreatment prior to membrane exposure. Please refer to technical bulletin 609-22010 for more information.

Note 

Proper start-up of reverse osmosis water treatment systems is essential to prepare the membranes for operating service and to prevent membrane damage due to overfeeding or hydraulic shock. Following the proper start-up sequence also helps ensure that system operating parameters conform to design specifications so that system water quality and productivity goals can be achieved.

Before initiating system start-up procedures, membrane pretreatment, loading of the membrane elements, instrument calibration and other system checks should be completed.

Please refer to the application information literature entitled “Start-Up Sequence” (Form No. 609-02077) for more information.

Avoid any abrupt pressure or cross-flow variations on the spiral elements during start-up, shutdown, cleaning or other sequences to prevent possible membrane damage. During start-up, a gradual change from a standstill to operating state is recommended as follows:

·         Feed pressure should be increased gradually over a 30-60 second time frame.

·         Cross-flow velocity at set operating point should be achieved gradually over 15-20 seconds.

·         Permeate obtained from first hour of operation should be discarded.

Keep elements moist at all times after initial wetting.

If operating limits and guidelines given in this Product Bulletin are not strictly followed, the limited warranty in Form No. 609-35010 will be null and void.

To prevent biological growth during prolonged system shutdowns, it is recommended that membrane elements be immersed in a preservative solution.

The customer is fully responsible for the effects of incompatible chemicals and lubricants on elements.

Maximum pressure drop across an entire pressure vessel (housing) is 50 psi (3.4 bar).

Avoid static permeate-side backpressure at all times.

.