Two Component Waterproofing materials polyurea coating water repellent harden primer for concrete floor outdoor
General description
HT200 is a high performance, two-component spray polyurea elastomer resin.
It is a polyurea elastomer resin composed of polyether, amine chain extender and isocyanate prepolymer.
It provides a flexible, tough and elastic dense coating with good water and chemical resistance.
Product characteristics
It can be sprayed on any curved surface, inclined surface and vertical surface without sagging.
Excellent physical properties, impact resistance, abrasion resistance, cold resistance, heat resistance, water resistance and aging resistance.
Convenient to use, adjustable color and unlimited spraying thickness
It has good crack bridging performance
It has good adhesion to all kinds of substrates.
It is solvent-free, 100% solid, safe and environmentally friendly.
Product application
Underground concrete structure, drainage pipe, manhole, etc.
The anticorrosion of steel beams and steel pipes, steel plates, silos and storage tanks.
The parking lot, factory, warehouse and shopping center floor.
Waterproofing and corrosion protection of offshore structures, piers and swimming pools.
The road ramp reinforcement and underground cavern waterproof and anti-corrosion coating.
Foam sculpture protection
HT200 Waterproof and anticorrosion | ||
Item | HT200-A (Isocyanate ) |
HT200-B (polyamines mixture ) |
Material | high reactivity polyethamine , content extender | methylene Diphenyklene Dissocyanate (MDI) base prepolymer. |
Package | 225kg/pump | 200kg/pump |
Viscosity (cps/25℃) | 500 - 1000 | 400 - 800 |
Density (g/cm3) | 1.1-1.2 | 1.0-1.1 |
Temperature setting | 65 - 70 | 60 - 65 |
Mixing ratio (by volume) | 1::1 | |
Elongation (%) | 400-500 | |
Tear strength (kg/cm) | > 90 | |
Tensile strength (kg/cm2) | > 16 | |
Hardness (shore A) | 85-95 | |
Wear resistance (mg loss ) | ≤100 | |
These items are provided as general information only. They are approximate values and are not considered part of the product specification. |
Surface treatment
The surface must be clean, dry and in good condition.
All oil, dust, grease, dirt, loose rust and other foreign matters shall be removed to ensure adequate adhesion. Steel, iron
Remove all oil and grease from the surface with solvent
clean according to sspc-sp1. Clean in accordance with sspc-sp10 / NACE 2, with a minimum of surface treatment and grinding to near white metal.
All surfaces shall be blast cleaned with sharp angular abrasive to obtain the best surface profile (3mils / 75microns)
All welding spatter shall be removed and all sharp edges shall be rounded.
The steel shall be primed on the same day as the steel is cleaned or before rust occurs.Whatsapp:008618265474887
Component A is 210kg/iron drum;
Component B is 220kg/iron drum.
One set: 430 kg=210kg A+220kg B
One 20' container loads 40 sets/80 drums