This harvester can complete the whole process of cob picking, transportation, peeling, packing, straw cutting and crusher into pieces.
After processing this machine, farmers no need remove the cob again and get good corn. High output and good effect at field.
model | TZY-2 |
type | Self-propelled |
power | 34kw |
Speed | 2400r/min |
Size | 4850*1450*2600mm |
Weight | 2680kg |
Row | 2row |
Width | 1135mm |
Spacing of row | 420-890mm |
capacity | 2.2-5.5km/h |
Advantage of corn cutter
1. There are 8 peeling rollers inside harvesting corn machine that can remove the skin of corn after harvesting, saving labor time.
2. Corn harvesting has big size, and it is more stable than other types during operation.
3. It integrates picking, conveying, peeling, packing and straw crushing as a whole.
4. The loss rate of corn is pretty low: less than 3%.
5. There is a cab on the upper of machine, and people can sit in it and run machine easily.
Common faults and related solution of corn cutter
(1) Straw blockage
Reason: The position of the picking board is not suitable (the gap is too close), and the transmission triangle belt is too loose.
Solution: Adjust the clearance of the picking plate to the appropriate size. Due to the different thickness of the straw, the tension of the transmission belt is adjusted between 20-50mm.
(2) The smashed straw is too long
Reason: The clearance of the movable knife is too long, and the blade of it is not sharp.
Solution: Adjust the clearance between the fixed knife and the movable knife ranging from 0.3-1.5mm.
(3) The peeling effect is not good
Reason: The peeling rubber roller is seriously worn,slipping from the driven rubber roller.
Solution: change the pressure of stripping roller by adjusting the bolts or replace the stripping roller.
(4) Common faults in the gearbox
Phenomenon: The gearbox has abnormal noise, oil leakage or overheating.
Reason: Gear or bearing is worn. Installation direction of oil seal is wrong or aging. Side gap is too close and there are little lubricant oil.
Solution: 1. Adjust the gear or bearing installation clearance.
2. Replace damaged parts.
3. Reinstall or replace the oil seal.
4. Tighten the bolts and adjust the oil to the appropriate height.