Taidacent 220V Delay Timer Module Adjustable Cycle Timer Delay On/off Switch Relay Infinite Loop Cycle Timer Switch
Specifications:
Voltage: AC100V~250V
Power: <1.0W
Output: Active output, output voltage equals to input voltage.
Max. Output Current: <10A
Input: Passive switch input, green led lights up after turn on, red led lights up after stop
Time Range: 0.5sec. to 1000min.
Time Accuracy: Max. range value*0.001
Input(start button): Passive switch input, green led lights up after turn on, red led lights up after stop
Start input is not necessary. Connect these 2 terminals and then the board will cycle infinitely after power on.
Size: 88 x 38 x 22mm / 3.46 x 1.49 x 0.86"
Mounting Hole Spacing: 83 x 33mm / 3.26 x 1.3"
Mounting Hole Diameter: 3.2mm / 0.12"
Voltage | AC100V to 250V |
Power | 1.0W |
Max current | 10A |
Instruction:
Time can be set when the board is powered on or powered off.
1. Set Run Time:
Adjust the RUN TIME potentiometer clockwise to increase, counterclockwise to decrease.
The red switch below can set time range(left, 0-100 or 0-1000) and unit(right, Sec. or Min.)
2. Set Stop Time:
Adjust the STOP TIME potentiometer clockwise to increase, counterclockwise to decrease.
The red switch below can set time range(left, 0-100 or 0-1000) and unit(right, Sec. or Min.)
3. Start Button(Not included):
Connect a momentary push-button switch and press it, then green LED lights up indicating it is working. The board would automatically run according to the setting run time and stop time, infinite cycle.Press the start button again, then red LED lights up indicating it stops.
Note:
1, Use a start button whose current is more than 0.1A
2, Electric Shock Alert, start button wire has high voltage, be careful please!