TGas-1031 Fixed Ammonia Meter
Brief introduction
TGas1031 fixed ammonia meter can detect the concentration of ammonia(NH3) gas, and offer 3 signals: a 4~20mA analog signal, a RS485 communication signal, and a switch signal. The signals usually are used to run the remote communication transmission and remote drive.
The meter comes with a remote control, and an alarm which is optional. The remote control can calibrate the transmitter without opening the cover of transmitter.
Technical parameters
Parameters |
Characteristics |
Target gas |
NH3 |
Measurement precision |
±5%F.S |
Repeatability |
2% |
Measurement range |
0~100ppm |
Response time |
<30s(T90) |
Sampling method |
Diffusion |
Working environment |
Temperature: -30°C to 60°C; humidity: below 85% (no coagulation) |
Remote control mode |
By the adjustment mode by infrared remote control, the detector can be adjusted without opening of cover |
4-20mA output |
4-20mA output corresponding to 0-100%, maximum load 800 ohms |
Alarm output |
The effective alarm is 1 point or 2 points; each alarm shall use SPDT electronic relay. Contact rating of alarm relay: Ohmic load: 5A @ 24V DC or 120V AC or 240V AC Inductive load: 50VA |
Communication |
Communication description: two-wire system parallel RS485 protocol, 32 points at most Connection: Twisted pair with shield Distance: maximum 1000m |
Input voltage |
24VDC±25%; power: 2W/way |
Certificate |
Explosion-proof grade: ExdIICT5 Protection class: IP66 CE certificate |
Using cable |
Larger than 2.5mm2×4 Screened cable line, outside diameter of cable is required to be between 6mm- 9mm |
Last Update Time:2014-01-03