Power-on | Keystroke once;Wait until READY! is displayed on the LCD. Now the gauge is ready for measurements. |
Zeroing | Keystroke twice; when BASE ZERO is displayed, place flat on surface; hold steady. After measurement is obtained, DONE is shown and gauge beeps. Then lift gauge. Note: Please conduct zeroing process after changing base. Zeroing process could be repeated for better results. |
Two-Point User Calibration | Keystroke three times, enter into the process of tow-point user calibration; when USER CAL BASE is shown on the LCD, please conduct a measurement on the base first; when S1 is shown on the LCD, place Shim S1 on the base, conduct a measurement on shim S1 and lift gauge; when S2 is shown on the LCD, place Shim S2 on the base, conduct a measurement on shim S2 and lift gauge; When DONE is displayed, it is ready for use. Note: The two-point user calibration process could be repeated for better results. |
Unit Change | Keystroke four times, convert from ums to mils or vice versa. |
Reset | Keystroke five times, gauge resets. |