Specifications
Model No. | INTL-CL621 |
Pulley DIA | 119mm |
Grooves | PV6 |
Volt | 12V |
Compressor Type | SANDEN 7V16 |
Car Model | For SEAT For VW |
Includes:
Clutch Hub, Pulley, Coil, Bearing
Specials Notes:
Bearing number:
35x55x20
OEM#
7M0820803M
7M0820803Q
535820803R
Sanden:
1160
1164
1114
Kindly remind:
This clutch be used for below compressor:
Factory & office
Basic Requirements when servicing an A/C system:
1, The Accumulator or Filter Drier should always be replaced when the Air Conditioning System is opened. For warranty Purposes buyer must show evidence of receiver/drier replacement. In some vehicles the drier comes attached to the condenser so it must replaced as well
2. A/C system must be clean and free of debris and contaminants. In most cases components can be flushed; however in some instances it may be necessary to replace the condenser or other items.
3. Orifice tube must be replaced; expansion valve must be inspected and replaced if dirty or defective.
4. Correct amount and type of oil must be used. Please refer to the OE manufacturer for this information.
5. Prior to refrigerant charging, full vacuum must be done for a minimum of 45 minutes. In humid climates or during cooler days, this time should be increased to effectively remove air and boil off moisture.
6. The Orifice Tube, if equipped, should always be replaced and the Expansion Valve, if equipped, should at least be inspected for proper operation if not replaced