Anchor Support and Restraint Systems
Direct fixing in to concrete walls with expansion bolts.
Indirect fixing on to sub channel system with hex bolts.
Three dimensional adjustability - Quick and easy fixing.
Installation at horizontal and vertical joints.
Recommended projection sizes up to 135 mm & loads up to 800 N.
Installation at horizontal joints
Suitable for concrete walls. Anchors are fixed directly on to concrete walls with expansion bolts.
Recommended projection size between 45 mm to 135 mm and loads up to 800 N.
In horizontal joint installation slabs are pinned on the bottom and upper sides. Anchors act as load bearing carrying half the weight of the slabs above. Anchors also act as restraints, holding the slabs below and restraining against wind suction and pressure.
In vertical joint installation slabs are pinned at the left and right sides. Anchors on the bottom are load- bearing anchors carrying the whole weight of the slab. Half the weight of the slab on the left and half the weight of the slab on the right. Anchors on the top are restraint anchors holding the slabs and restraining against wind suction and pressure.
Three - dimensional adjustability allows quick and easy installation.
The design and structural calculations of these anchors are made in our technical department. Special design and manufacturing can be made for the requirements of each project.
Why Choose us? High quality with certifications:
Please kindly let us know if you have any inquiy.
Contact information:
Susie Liu
Email: cnzhenya024 at cnzhenya.com
Skype: susieliu.1204
MSN: susieliu_ at hotmail.com
Tel: 0086-15919768735