Usage:: Appliance Paint, Boat Paint, Building Coating, Car Paint, Electrical Insulating Varnish, Furniture Paint, Paper Coating, Plastic Coating, Road Marking Paint, Metal spray

Application Method:: Spray

State:: Powder Coating

Brand Name:: Feihong

Model Number:: RAL Color

Substrates:: alumium,steel,metal ect.

Application method:: electrostatic spraying

Color:: RAL or custom

Gloss:: high/low/matt

Texture:: hammer/wrinkle/crocodile/sand/ect.

Curing:: 180-200℃/6-15mins

Shelf life:: 12 months

Supply Ability

Supply Ability:: 5000 Ton/Tons per Year

Packaging & Delivery

Ral 9006 aluminum powder coating

INTRODUCTION

FH-MP Series is metallic finish powder coatings with highly decorative finishes available in any of chemistry types e.g. epoxy, polyester and epoxy-polyester. To preserve the decorative appearance of polyester-based metallic finishes for outdoor use, a clear topcoat is highly recommended.

FEATURES

Metallic / Pearl powder coating is a range of metallic effect powder mixed with pearl pigments ,copper,gold or aluminum silver # pigments, offering various colorful metal shining effects.
Offering considerably improved mechanical properties and chemical resistance.
Available in a range of chemistry types and can be custom matched as per user’s requirements.
Clear Topcoat is recommended to overcoat.
Dry blending or bonding options

Bonded (FH-MP-B) and dry blending (FH-MP-D) metallic powder have very different properties during application .Both of them are optional according to your requirement.

Bonded Metallic Powder (FH-MP-B)

Base powder and metallic pigments does not be divided
Can use after reclaimed
Reclaim to virgin powder ration be kept as low as possible
High Metallic Effect
A little bit expensive
No defects on a coated film
Rejection ration Below 5% Metallic Powder had been combined with base powder

Dry Blending Metallic Powder (FH-MP-D)

Base powder and metallic pigments can be divided
Can not use after reclaimed
Tends to separate from the power during application
Low Metallic Effect
Cheaper than Bonded Metallic Powder
Defects (spit, lump etc.) on a coated film
Rejection ration 30~40%
Base powder and metallic powder have been detached

GLOSS AND COLOR RANGE

Gloss levels range from matt to high gloss depending on the chemistry system.
Smooth, flat metallics or sparkling metallics are available.
Colors is matched upon request , no full color range is available.

APPLICATION SCHEDULE

Applied by electrostatic spraying gun that can provide negative tension of 60-80 kV.
Curing schedule : 180-200°C /10-15 minutes depending on the powder chemistry system.
Optimal film thickness : 60 -90 um

The metallic finish obtained depends on the coating thickness. Excessively thin or thick films will not give a satisfactory finish.

SUBSTRATES AND PRE-TREATMENT

Applied to the following substrates after the appropriate cleaning and conversion coating.

Ferrous metals(cold rolled steel, cast iron etc.): Iron or zinc phosphatation
Zinc surfaces(galvanized steel, zinc alloy) : Chromatation or zinc phosphatation
Aluminum alloys : Chromatation

STORAGE

Should be stored under dry conditions with good ventilation at a temperature not exceeding 30 C.
Storage period recommended should not exceed 6 months, in case exceeding 6 months without affecting their free flowing properties, the powder will still have optimal characteristics.
Should be protected from excessive heat, humidity, water and contamination with foreign materials such as powder, dust, dirt, etc.
Any leftover powder should be kept in an appropriate area that is cool and dry. Do not expose to the air too long as the powder properties may deteriorate with the moisture

We offer powder coating capabilities that include a wide spectrum of colors, thickness, textures, softness, edge coverage, flexibilities, machinabilities, smoothness and temperature ranges. Free samples are available.