RS232 to USB Serial DB9 Cable Converter
HighTek HU-02 is a universal USB/RS-232 interface converter. No external powersupply needed. Compatible with USB and RS-232 standards, HU-02 iscapable to perform the conversion from single-ended USB signal into UARTsignal of RS-232. DB9 male connectors are used for connection from RS-232interface. The unique I/O circuit of the internal zero delay auto transceivercontained in the converter controls the data stream direction automatically.
Functions
HU-02 interface converter supports the following communication mode:
1. Point-to-point communication mode.
Hardware installment and application
Read the user manual carefully before installing the HU-02 interfaceconverter. Put the signal cable of the equipment into the USB socket.
USB/DB9 male connectors are adopted for input/output interfaceconnection for this product.
Performance parameters
Connector and signal
1. DB9 PIN: RS-232 output signals and PIN assignment.
2. USB-B female: USB output signals and PIN assignment
Communication Connection Chart
1- Standard USBAtype male connector
2- Filter magnetic pole
3- Transparent and shielded standard 2.0 communication line
4- Fine shell(blue)
5- Standard DB9 male connector
6- MCU adopts the product of the TaiWan chip
USB to RS-232 Communication
DCD 2,RXD 3,TXD 4,DTR 5,GND 6,DSR 7,RTS 8,CTS 9,RI
Problems and troubleshooting
1. Data communication failure
A. Check to make sure USB cable is OK.
B. Make sure RS-232 output interface connection is correct.
C. Make sure power supply is OK.
D. Make sure the wire terminal connection is OK.
E. Make sure the indicator lights flash when receiving.
F. Make sure the indicator lights flash when sending.
2. Data missing or incorrect
A. Check to see whether the data rate and format at both ends of thecommunication equipment are consistent.
USB to RS232 Serial DB9 Adapter Cable Profile Display:
Our Factory Display: