IT-100 TV signals multisystem analyzer is designed
to measure signals parameters of digital and analog television. The analyzer can be used when checking and servicing cable coaxial, fiber-optic or IP networks for receiving television and radio broadcasting, separate elements of network building and
other radio electronic devices.
Analog television: support for PAL, SECAM, NTSC standards.
Measured parameters: Level, Video/Audio, Carrier/Noise (inband and outband of video signal), modulation depth, unwanted modulation level (HUM), CSO&CTB distortion components level.
Cable digital television: support for DVB-C, ITU-T J.83 Annex B, C standards.
Measured parameters: power, MER, BER, constellation diagram, error analysis over time.
Terrestrial digital TV broadcasting: support for DVB-T, DVB-T2 standards.
Measured parameters: power, MER, BER, constellation diagram, echo diagram, error analysis over time.
Satellite broadcasting digital television: support for DVB-S, DVB-S2 standards.
Measured parameters: power, MER, BER, constellation diagram, error analysis over time.
IP digital television: support for UDP and RTP protocol, reception of the Transport Stream through unicast and multicast (IGMPv2).
Measured parameters: average bitrate, number of lost packets (for RTP), jitter of packets arrival interval.
• Create and edit channel plans, limit plans, satellites and LNB profiles
• Copy, move and delete files on IT-100 and USB flash drive connected to PC
• View measurement results in a convenient form
• Synchronize data between PC and the Meter
• Software for OS Linux is available on request.
Main Menu Mode
Full Scan in Limit Mode
Full Scan in Tilt Mode
Channel Mode for digital channels
Channel Mode for analog channels
Autotest Channel Mode
Autotest Channel Mode
MPEG TS analysis Mode
MPEG TS analysis Mode
TV picture Mode
Spectrum Analyzer Mode
Channel Mode for satellite channels