CT test equipment Q50A Transformer 1000A/1V Clamp on current sensor
Clamp-On Current Sensor Industrial Current Sensors are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for Clamp-On Current Sensor Industrial Current Sensors.
Clamp on Sensor for Easy mounting. Proteus comes with current sensing technology that does not need any cutting or splicing of your power cord. Simply clamp on the sensor node over your power cord, and connect to the base unit. Simple and easy.
Q50A current sensor are a 1Hz to 2 MHz AC current sensor ideal for measuring low frequency equipment such as inverters. CAT III 600V Key Features • Superior low frequency and phase characteristics suitable for testing the current and power of inverter control devices • Wide 1 Hz to 2 MHz frequency bandwidth perfect for harmonic analysis, FFT analysis and waveform monitoring.
Q50A Suitable for 1000 A cable online measurement.
Holding wire diameter:Φ50mm
Dimension:101mm×219mm×26mm
With load capacity: ma output≤4Ω, 1A output 0.1Ω, 5A output 2.5VA
Installation: clamp type
Output mode: lead output
Electrical parameters | |
---|---|
Ratio | 1000: 1 or 2000:1 (customized) |
Accuracy class | 0.1%, 0.2%, 0.5% |
Primary current | 0 - 1000A AC |
Secondary current | 0 - 5A AC (customized) |
Max. Cont. Input current | 1200A |
Over voltage category | CAT III 600V |
Output signal | 500mA,1A,5A AC at nominal input current |
Frequency range | 40Hz-2000Hz |
Dielectric strength | 3KV 50Hz/60Hz at 1 minute |
Temperature range | -20°C to +55°C |
Output | 2.5 meter cable with D01 connector |
Max. voltage not insulated conductors | 600 V |
Standard | EN 61010-1, EN 61010-2-032, IEC60044-1 |
Installation | Clamp type |
Output mode | Lead output(2.5m) |
Mechanical parameters | |
Dimensions (L x W x H) (mm) | 102.9 x 219.6 x 28 |
Weight (g) | 550 |
Holding wire diameter (mm) | φ50 |
Max. jaw opening (mm) | 50 |
Jaw Color | Blue |
Material | PC+ABS+Polycarbonate, UL94 V0 |