Programmable Vacuum Chuck Spin Coater with Optional Heating 500-6000 rpm, 8" wafer Max

• Aluminum casting case to keep spinning stable
• Drainage outlet and vacuum pump connector are on back panel
• One filter is included in standard package. It is used to connect the pump and coater for preventing waste water from flowing into the pump
• One oilless pump is included in the standard package. 

Chamber  & Vacuum Chuck 

• Chamber diameter is 250 mm, and can accept wafer 8" Dia max. or 5"x5" square
• Spinning chamber is made of PP which is corrosive resistant 
• One 6" vacuum chuck and chuck o-ring are included for holding 6" and 8" wafers
• 1 piece of Adhesive tape (6'' W x 24'' L) is included  for coating irregularly shaped substrates or wafer with size < 6"

• Digital control panel with two programmable segments of different spin times and speeds
• 500 - 6000 RPM adjustable spinning speed for each segment

• 20mL syringe is used to contain the coating material
• The syringe holder height can be adjusted and rotated freely along the support rod

• AC 110V/220V selectable
• There is a built in power socket on the right side of the  VTC-200 spin coater. It is used to supply power for the vacuum pump. The output voltage of this power supply depends on the input voltage of the spin coater's main circuit. (e.g. if the spin coater is plugged into the AC 110V power socket, then the built in power socket will supply AC 110V)