a: In the off state (non-charging state), long press POWER 2S to turn on, and long press POWER 2S to turn off.
b: When the machine is in the charging state, no button will respond.
c: After connecting to the gel (or fake load) adhered to the human skin, press and hold the POWER button for a long time to automatically enter the gear intensity 1 of mode 1. During use, exit the power-on state (shutdown output) as long as the following four One of the conditions:
A: Long press the POWER button for 2S
B: Enter charging mode
C: Low battery power off
D: Host-gel sticker-body phase separation (host is unloaded).
d: The three modes of this machine each have 10 intensity gears. Use the + and-buttons to adjust the output intensity.
e: After switching on and switching modes, the output automatically switches to intensity 1.
f: Automatically enters mode 1 (primary mode) after booting. This machine has 3 built-in modes. Short press the power button to cycle between 3 modes. At the same time, the mode indicator has a corresponding color prompt. The primary mode is a white indicator (Square wave output), the intermediate mode is a green indicator (sinusoidal envelope output), and the advanced mode is an orange indicator (sinusoidal envelope output).
g: When the machine is working (outgoing wave), it plugs into the charger and automatically turns into the charging state to stop the outgoing wave.
h: After the unit is plugged into the charger, if the battery level is below 100%, the white charging indicator flashes (about once every 1s) to indicate that charging is in progress. When the current is less than about 5mA), the charging indicator turns solid green, and the charging indicator goes out and remains off after unplugging the charger.