PPL / PTFE - Lined Hydrothermal Reactor With Gas Inlet

also called pressure vessel, dissolved vessel or hydrothermal synthesis Vessel

Capacity and Material of Hydrothermal Reactor With Gas Inlet:

Capacity: 20ml 30ml 50ml 75ml 100ml 200ml 400ml 500ml 1000ml 2000ml 

Outside Shell Material: Stainless steel SS304, SS316, hastelloy, titanium, cladding plate

Lining Material: PTFE, PPL.

Structure of Hydrothermal Reactor With Gas Inlet:

(1) Jack screw bolt

(2) kettle cover

(3) Butterfly spring pad

(4) Flat Head 
(5) Liner cover

(6) Liner

(7) Bottom cover

(8) Kettle body 

Function of Hydrothermal Reactor With Gas Inlet: 

The design temperature of this product is 220°C / 280°C, design pressure 3Mpa.
There are two types of working temperature according to the different liner in the hydrothermal synthesis reactor. 
Teflon lining ( also caleed PTFE,F4) ≤ 220 °C
PPL lining ≤ 280 °C

Operation of Hydrothermal Reactor With Gas Inlet:

1. Loose hexagon head bolt with a wrench, do not have to unload and just move freely.

2. The screw cap is screwed down, and then turn to the 304 filter pad , 304 cover and PTFE cover to be taken down.

3. Withstand up the 304 bottom, then remove the 304 PTFE liner from upper part of the kettle.

4. Place the reaction materials inside the PTFE liner, and ensure that feeding coefficient is less than 0.8.

5. Put PTFE liner with reaction materials into the 304 kettle body, and then turn to put on PTFE cover,304 cover, 304 filter pad, then tighten the screw cap, and finally tighten the hex head bolt with a wrench.

6. Fix the micro reactors in blast / thermostatic oven, pending the completion of the reaction to remove micro-reactors.

7. After cooling the micro-reactor, repeat the steps 1-3

8. Transfer the reaction products to the specified container, then wash PTFE liner and PTFE cover for the next use.

Hydrothermal Reactor With Gas Inlet in Stock: 

Please feel free to contact us!