1. Brief introduction of Turbine Flow Meter
Turbine Flow Meter is designed for usage in water, diesel, gasoline and other fluid measurement and control systems. They operate according to the turbine principle, the speed of an impeller turning in the fluid flow is measured and converted into pulse or 4-20mA signals.
Turbine Flow Meter is suitable for petroleum, chemical, metallurgical and other sectors, and are used for measurement of low-viscosity liquids such as water, gasoline, and diesel.
Long service life, high accuracy and strong reliability. The pressure loss is extremely small.
1. LCD. Intelligent liquid crystal meter head, filter and anti-impurity interference ability is strong and the unit can be switched.
2. Power supply can use external power 24v or 3.6v lithium battery.
3. The impeller life is durable and has strong impact resistance.
4. The flange material is made of all 304 stainless steel, which has good processing performance, high temperature resistance and is not easy to rust after long-term use.
Sensor Diameter | DN 4-300mm |
Accuracy | 1.0%, 0.5% |
Measured medium temperature | -20℃~120℃ |
Power supply | 24VDC 3.6v |
Range ratio | 1:10 1:15 1:20 |
Nominal Pressure | 1.6MPa, 2.5MPa, 4.0MPa, 6.3MPa and pressure over these |
Signal output | Pulse/4-20mA/RS485/Hart etc. |
Diameter (mm) | Standard flow range (m³/h) | Extended flow range (m³/h) | Extended flow range (m³/h) | Conventional pressure (Mpa) |
DN4 | 0.04-0.25 | 0.04-0.4 | Thread | 6.3 |
DN6 | 0.1-0.6 | 0.06-0.6 | Thread | 6.3 |
DN10 | 0.2-1.2 | 0.15-1.5 | Thread | 6.3 |
DN15 | 0.6-6 | 0.4-8 | Thread/Flange | 2.5/6.3 |
DN20 | 0.8-8 | 0.45-9 | Thread/Flange | 2.5/6.3 |
DN25 | 1-10 | 0.5-10 | Thread/Flange | 2.5/6.3 |
DN32 | 1.5-15 | 0.8-15 | Thread/Flange | 2.5/6.3 |
DN40 | 2-20 | 1-20 | Thread/Flange | 2.5/6.3 |
DN50 | 4-40 | 2-40 | Flange | 2.5 |
DN65 | 7-70 | 4-70 | Flange | 2.5 |
DN80 | 10-100 | 5-100 | Flange | 2.5 |
DN100 | 20-200 | 10-200 | Flange | 1.6 |
DN125 | 25-250 | 13-250 | Flange | 1.6 |
DN150 | 30-300 | 15-300 | Flange | 1.6 |
DN200 | 80-800 | 40-800 | Flange | 1.6 |