Microwave Equipment Inverter, 2450MHZ 1500W Microwave Magnetron AC DC Power Supply
Product description: Industrial Microwave Equipment Inverter
Application: Industrial heater, dryness equipment
Microwave Equipment Inverter, 2450MHZ 1500W Microwave Magnetron AC DC Power Supply
Revision History
Revision | Change Item | Date |
1.0 | Initial Release | 2012-3-20 |
1.1 | Add installation instruction | 2012-9-25 |
1.2 | Add filament specification | 2013-1-23 |
Microwave Equipment Inverter, 2450MHZ 1500W Microwave Magnetron AC DC Power Supply
Electrical Specification
1.1 Input Electrical Characteristics
Input voltage range | 180Vac to 264Vac |
Normal voltage range | 200Vac to 240Vac |
Frequency range | 47Hz-63Hz |
Max input ac current | 10A max. At full load condition |
Leakage Current | Less Than 0.5mA@240Vac input |
Regulation input power range | 500-1600W(note 1) |
Max. Endure input voltage | 300Vac |
Note 1: This product has a backward compatible function, before the use of communication power function, you must first apply the communication signal to the inverter power supply, otherwise the product can only run at fixed 1250w input power.
1.2 Output Electrical Characteristics
Rated Output Anode HV | 4200Vdc |
Rated Anode Output Current | 360mA |
Rated Filament Voltage | 3.3V |
Rated Filament Current | 10A |
Note: This inverter is applied for general using industrial magnetron.
Microwave Equipment Inverter, 2450MHZ 1500W Microwave Magnetron AC DC Power Supply
1.3 Protection
AC RMS OVP | 275VAC |
AC RMS UVP | 165VAC |
AC OCP | 10A |
OTP | 88℃ typ |
Arcing Protection | Y |
1.4 AC Voltage VS Output Power
Power on Sequence
Parameter | Function | Min. | Typ. | Max. | Unit |
T1 | System Power on | 200 | 500 | 1000 | ms |
T2 | Lamp filament preheat | 500 | 2000 | 4000 | ms |
Reliability
ON/OFF test: After applying 15000 times on/off test, included on for 4 minutes and off for 2 minutes, total test period is 1500 hours, unit shall work normally.
4.Isolation
4.1 Insulation Resistance
The insulation resistance of 100Mohms shall be ensured at application 500VDC between AC line and earth for 1 minute.
4.2 Table 13 Dielectric Strength
1500V AC between AC line and earth shall be withstood for 1 minute.
5. Safety
The power supply shall comply with the following criterion:
GB4706.1/IEC60335
6.EMC
The power supply shall comply with the following criterion:
6.1 ESD
N/A
6.2 EFT A
GB17626.4-1998/IEC61000-4-4
Level 1 L/N-Earth
6.3 SURGE C
GB17626.5-1998/IEC61000-4-5
Level 2 L-N 1KV 2ohms
L/N-Earth 2KV 12ohms
A: Throughout the test, there is no reduction of performance, completely same index with the specifications specified in the instruction.
B: During the test, the performance of the power supply is allowed to be temporarily reduced, but it can return to normal after the test.
C: Allowing short-term loss of function, but the end of the test it can be automatically or manually return to normal.
R: No damage to the device other than the safety device during the test.
7.WEEE/RoHS
Products comply with environmental directives
8.Environmental Requirement
8.1 Temperature
Operating temperature: -20℃ to +50℃
Storage temperature: -40℃ to +85℃
8.2 Humidity
Operating: from 10% to 90% relative humidity(non-condensing)
Storage: from 5% to 95% relative humidity(non-condensing)
8.3 Altitude
Operating: -60 to 3000m
Storage: Up to 5000 meters
8.4 Cooling Method
Forced air
Microwave Equipment Inverter, 2450MHZ 1500W Microwave Magnetron AC DC Power Supply
9. Dimension
9.1 Installation dimension:
When installation using the M4 combination screws, total 4 parts.
9.2 cable length of filament
1600mm
10.Weight
2600g
11.Assembly
11.1.1 The rated length of the high voltage output cable is 1.8m, if needed to be changed, users should consult with the manufacturer. Otherwise, it may can not be matched with magnetron.
11.1.2 Safety valve can not be covered, parcels, users should check its function each year.
11.1.3 The first time to use, you should tear off the gasket on the exhaust port to ensure the normal flow of gas during normal work.
11.1.4 AC input ground wire can be string into the ammeter to monitor the magnetron power.
11.1.5 Be sure to install a reliable grounding hole to prevent accidental clicks!
11.1.6 This product has a backward compatible function, before the use of communication power function, you must first apply the communication signal to the inverter power supply, otherwise the product can only run at fixed 1250w input power.
12.Cautions
12.1 The four holes on the case edge are only used for earth ground connection. Must connect them to earth ground directly.
12.2 Cooling air or oil speed and direction should be considered properly when mounting the inverter to a microwave equipment, pool cooling may cause the reliability decreased.
12.3 More than 8KV high voltage inside the inverter, do not touch any components on the board before disconnect the inverter.
Carton package.
1, we ensure the goods will be arranged to be shipped in 2 working days if it is in stock, if not, within 5-15 working day is promised.
2. We will discuss the shipping details with our customers, choosing the best way, to help them in transportation.
3. We accept picked up from our company by the carrier, who cooperated with our customers and got a authorization from our customers.
4. Generally we will use DHL, UPS, EMS, FEDEX, TNT or airfreight, if need to be sent by sea, we can discuss together.
1. All the parts we offer is new and original.
2. If the goods you buy from our company is not complete, the goods must remain their original condition. We can give you a replacement, but the freight must be paid by the buyers. If it really our problem. Then we will separate decision.
3, We assure you that goods will be well packaged, if it was broken when it arrives to you, please tell us as soon as possible, take photos and keep it as it was, we will help to settle the situations.
4, Trade Manager, WhatsApp, Wechat, Telephone... enables us to connect with each other quickly, so please feel free to contact us.
Henan Xinhang microwave technology CO,.LTD main products including Microwave drying and sterilization equipment, microwave magnetron, transformer, high voltage silicon stack, oil cooling transformer group, waveguide microwave and other components. Especially our magnetron water cooling jackets and microwave transformer groups(magnetron power supply) got patents from the State Intellectual Property Office in 2012.