Manual Wire Stripper Multi Tool for Coaxial, Network and Telephone Cable HM-ST352

Universal RG59 RG6 Wire Stripper with Multi-function HM-ST352  

>For Coaxial Cable RG-59/6/7/11, Round UTP/STP Cat.5/5e/6/6e Network Cable, and Flat Telephone Cable

>Multifunctional, Stripper & Cutter. Strip coaxial jacket and inner conductor and cut wires

>Reversible Cassette

>Adjustable cable length

>Simple to operate

>Good quanlity

Instructions:

1.Push the cassette out of the housing, push from the front of the cassette. Cassette is reversible, one side is available for RG59/6 and another side is for RG7/11.

2.For stripping coaxial cable:
a.Insert the cable until it aligns with the cable guide.
b.Insert your index finger into the stripper's finger ring, rotate the stripper by counter clockwise 3-5 times. The cable insulation is cut while you are turning the stripper.
c.Open the jaws and remove the cable. Pull away the outer jacket and dielectric to expose the inner conductor.

3.For stripping round networking cable:
a.Insert the cable into the second stripping hole, rotate 1-3 times at counter clockwise, and then open the jaw and remove the ourter jacket.
b.The black color adjusting knob is for adjusting the blade's depth. Turn clockwise for increasing the blale's depth and counter clockwise for reducing the depth.

4.For cutting coaxial calbe, round networking cable or flat telephone cable, place the cable in position and then squeeze the handles.

5.For stripping flat cable, insert the cable between the stripper blades. Squeeze handles, cable must be kept perpendicular and then pull from the tool.

Insert 4P/6P cable into the two-bladed side of the tool's stripper until it touches the stop guide.

Insert 8P cable into the two-bladed side of the tool's stripper and let it extend a litter past the lower cut blade