Brief Introduction
FZG gear wear test machine is a multi-purpose testing machine. Can be used for the assessment of the carrying capacity of the lubricant, Also can special made by client's demands. Usually using for gear bending fatigue strength and gear touch fatigue strength test.
II. Apply for:
This machine confirms to GB/T 13672-92 standard test method for scuffing load capacity of gears and SH/T 0366-1992 lubricant carrying capacity test method (CL-100 Gear machine method)
III. Technical specification:
Specification MR-C1
Max. torque 1Kn. m
Max. loading class 13 classes
Temperature control accuracy ±2℃
Motor power 6.5/8kw
Motor speed 1450/2880 r/min
Gear box volume 1.25L
Heating power 0.5X3=1.5kw
Dimensions 1390X750X1082mm
IV.Working conditions
1> The fluctuation range of the power supply voltage should not exceed the rated value ± 10% and the fluctuation range of the frequency should not exceed 2% of the rated value.
2>Test machine should be installed horizontally and the installed base should be smoothly. The horizontal error for the host workbench aspect direction should not exceed 0.2/1000.
3>Room temperature 10 º C-35 º C.
4>The environment no vibration, no strong magnetic interference and non-corrosive media.
5>Relative humidity less than 80%.
V. Structural characteristics and working principle
1> Loading mode
This machine is a dynamic closed-loop configuration, and load mode adopts rod hanging weights mode.
The loading lever is hung on the load sheave clutch. By hanging weights plus through fastening loaded clutch nut and make the two sheave tighten which installed on the loaded clutch. Then remove the weights and the loading lever and you can readout the torque on the clutch torque measurement.
3> Installation and adjustment
Make the test machine at the level of the floor and mat three horns. Put the spirit level on the test table. By adjusting the horn to make the vertical and horizontal direction error do not exceed 0.2/1000.
The test machine host should be placed separately from the control cabinet to avoid the noise and pungent odor when the testing machine working. After the start of the test machine, person can not inter into the room which the machine placed.
The test procedure in accordance with the the "lubricant carrying capacity assay (CL-100 gear machine method) SH/T0306-92" provisions.
Spindle drive device of testing machine
The shaft 5 is drive shaft, the shaft 3, 12 ,10 is drive shaft
Customer from India
Customer from Canada
Customer from Bangladesh
Customer from Bangladesh
Customer from Russia and Germany
Customer from Africa
Jinan Chenda Testing Machine Manufacturing Co., Ltd. was established in 2003, and is a professional comprehensive company which integrates research and development, production, marketing and service. Our products are applied widely in many fields such as scientific institutions, colleges, metallurgical, construction materials, railway trains, highway traffic, rubber plastic, wire and cable, and fire facilities.
Our company is located in the beautiful spring city - Jinan, which is the center for developing testing machines in China as well as the largest testing machines producing base at home.
We are specialized in providing:
1. Hydraulic universal testing machines
2. Electronic universal testing machines
3. Friction and wear testing machines
4. Complete impact testing equipment and bending testing machines