Q: On initial installation, motor fails to start up,what to do?
A: Likely cause: Motor is incorrectly wired
What to do: Verify that the motor is wired correctly.
Likely cause: No output power from controller
What to do: Measure voltage coming from the controller.
Likely cause:Motor coil burned out
What to do: Disassemble the motor and see if the coil is burned out. May need to replace the motor
Q: Motor runs in the wrong direction,what to do?
A: Likely cause: Incorrect wiring
What to do: Interchange the two motor leads.
Q: Motor runs OK but has a clicking noise,what to do?
A: Likely cause: Suspected tail speed control coil
What to do: Use a screwdriver to remove the tail screw and re-fix the speed control coil