Feature:
• Good film-forming toughness, after curing, it plays a role of insulation and protection
• Insulate and protect electronic components in the later stage of welding, repair computer, mobile phone PCB circuit board solder mask peeling or partial damage, fix insulating enameled wire, protect components.
• Scope of application: PCB circuit board/Cell phone Motherboard/computer Motherboard/Appliance Repair, etc.
Specification:
Material: Solder Mask
Capacity: 100g
Color: green oil
Dielectric Strength: >500V/mil
Solvent Resistance: Trichloroethane boiled for 2 minutes without falling off
Solder Resistance: 255-265 degree 10s * 3 times
Hardness: >5H
Curing Condition: UV light
Note: This product is sensitive to ultraviolet rays and needs to be stored strictly away from light
Instructions:
1. When the PCB circuit is broken during the maintenance of the computer or mobile phone, first use the enameled wire to solder the flying wire;
2. Prepare tools (such as brushes) and green oil;
3. Squeeze a little bit of green oil onto the brush, and then evenly apply a layer of green oil on the PCB board;
4. Put it in the natural state for a few hours. If possible, you can irradiate it with ultraviolet light for a few minutes. Shake the PCB board to observe that the ink is no longer flowing. The green oil will fix the lead well and play a good insulation effect.
Special Purpose:
When the main board drops when the north-south bridge is used, we can use enameled wires to make solder joints, and then fly wires on the pads to connect, and the paint is green.
Package Included:
1 * Green Oil UV Solder Mask