ISO Certification Factory Supply 220v Single Phase Capacitor Bank , Capacitor Bank Panel

structure features

1 taking cylinder aluminum case

2 immerse liquid:no social effects of pollution dielectric oil

3 inseting press detaching equipment and discharge electric resister

4 capacitor core is healing good quality metallized film

5 capacitor top is anti touching electric terminal block

6 bottom is M12 or M16 install ground bolt

7 three phase capacitor is inside connection way

Technical parameter

1 Rated voltage:0.23KV,0.25KV,0.4KV,0.415KV,0.45KV,0.48KV,0.525KV and so on

2 Rated capacity:1~30kvar

3 capacity tolerance:-5~+10%

4 power loss tgδ≤0.01

5 anti voltage:between two pole 2.15 time rated voltage is 5s,no permanence puncture or shine

6 dielectric level:between cover add the voltage:2 times rated voltage plus 2KV or 3KV,please take height continue 10 second,no puncture and shine

7 max permit voltage:1.1time rated voltage,the high permit over voltage is not more than 8 hours within 24 hours.1.15 time rated voltage,it is not more than 30 minute within 24 hours,1.2 time rated voltage it is not more than 5 minute,1.3 times ratedvoltage,it would not more than 1 minute

8 max permit current:it is permit that the over current is not more than 1.3 time rated current,interim over current it should consider over voltage,capacity positive tolerance and harmonic effect. Interim over current is not more than 1.43 time rated current.

9 connection:Ytype,Y type should draw out through neuter,III three section,single phase type,and all kind of connections way. Other connections way it will notice when you order it

10 discharge component:inside put discharge register,capacitor cut off power,than discharge 3 minutes electric,so the voltage reduce to 50V

11 Standard:IEC60831-212002 / GBT12747-2004

Working Conditions

1. Power capacitor should confirm left voltage reduce to rated voltage 10% to input  again after the power was cut off, normally it will need 200s almost. so it would  choose the power controller which has input and reput lock time function after  cut off the power. If choose normally power controller, it must install speediness discharge power equipment. it would not limited which use adopting same electric factor input and chip switch.

2. Altitude level is not more than 2000m.

3. Temperature type: -25/C low temperature, highest temperature is C type (it would  not more than 50°C the average of temperature is not more than 40°C within 24  hours, one year average of temperature is not more than 30°C), power capacitor  will work within good ventilate condition. It would not permit within sealing and installation condition.