final sssembly the relay could change its state to the "release"position. Pleade reset the relay into "operate"
state when put in circuit according to need.
2.In order to maintain "operate"or"release"state of the relay, the coil voltage should reach
the rated voltage.The pulse width should be 60ms or longer to ensure a proper change of state.
Do not energize both pin1 and pin2 at the same time on the coil for longer than 1 min(damage to the coil)
3.Relays are classified according to the polarity, if client need different form from information,please contact us.4.The relay into the factory for destructive inspection should be protected from damage and srrict distinction
between the normal products.
5.Not with braided line relay,the load pin can not solder,not arbitrarily wrenched,two pins and rigid fixation.