Hot Selling Battery Sprayer Pump Trigger Dino Power Electric Airless Paint Sprayer Hand Sprayer Germany With Low Price

Brief introduction:
Manual sprayer is widely used in general industrial equipment, medical equipment, chemical equipment, agriculture (lawn and
garden), tourist vehicles, special vehicles, ships, drinks, vehicle cleaning, carpet cleaning, ground cleaning, water purification
and water treatment equipment.

Introduction of installation and usage:
1. Parts of sprayer should be installed correctly.Check the connection for air leakage. When using, install water spray test
first, and then install the medicine.
2. Prepare pesticide before operation according to operating procedures and strictly follow the use instructions of drugs.Before
filling liquid to the liquid barrel, must turn off the switch, in order to avoid liquid leakage, filling liquid to filter with a
filter, and the liquid level of liquid cannot exceed the safe water level.
3. Carry the sprayer on the back, hold the pressure bar in the left hand and press it up and down to a certain pressure (about 30
times/min). Open the switch with the handle of the spray bar in the right hand and swing the spray bar.
4. During the initial charging, due to the presence of water in the air chamber and spray rod, the concentration of the spray is
relatively low in the first 2-3 minutes of spraying, so attention should be paid to spray, so as not to affect the control effect
of diseases and insect pests.
5. When spraying, it is necessary to pay attention, cooperate with your hands and eyes, and apply pesticides in a rhythmic manner.
Aim the nozzle at plant parts affected by diseases and insect pests, and apply pesticides in a thoughtful, uniform, correct and
safe manner.
6. After the work is finished, the residual liquid in the bucket should be emptied in time and drained with clean water.
Meanwhile, check whether there is any water in the air chamber.
7. If the sprayer is not used in the short term, the main parts should be cleaned, dried and installed, and stored in a cool and
dry place.If not used for a long time, the metal parts should be coated with butter to prevent rust.
8. Within 48 hours after using the drug, if any pesticide damage is found, the detergent solution of 1%~2% should be sprayed
immediately, or the water should be sprayed several times to alleviate the pesticide damage and reduce the loss.