Volvo VOAC JCB V12-060 V12-080 V12-160 V14-110 V14-160 T12-060 T12-080 T12 Bent Axis Hydraulic Variable Parker V14 V12 Motor

Bent Axis V12-060 V12-080 V12-160 V14-110 V14-160 T12-060 T12-080 V14 T12 Hydraulic Variable Axial Pison VOAC VOLVO Parker V12 Motor.

Series V14
Series V14 is a new generation of variable displacement, bent-axis motors, a further development of our well known V12 motor.
It is designed for both open and closed circuit transmissions with focus on high performance machines .
Applications
• Excavators
• Forestry machines
• Mining and drilling machines
• Wheel loaders
• Winch drives
Optional equipment
• Integrated sensors for speed and displacement
• Integrated flushing and pressure relief valves
Additional benefits (compared to those of the V12)
• Improved speed capability
• Improved control performance
• Reduced number of parts
• Stronger shaft bearing support.  

The Series V12 is a Bent Axis, Variable Displacement Motor. This renowned series of impressively engineered motors is intended for both open and closed circuits has been specifically designed for the most demanding mobile applications. However the V12 can also be utilized in a wide variety of other applications. Available in 2 sizes in ISO, SAE and Cartridge versions. The small envelope size makes for a clean and cost-effective installation. 

Rigorous product testing and continuous product development help to ensure our hydraulic pumps operate at optimum efficiency and can perform in the most demanding environments. 

Markets:

• Mobile

• Natural Resources

• Government 

Features/Benefits: 

• Displacement 60 cc and 80 cc

• High operating speeds thanks to low weight pistons

• Wide displacement ration (5:1)

• Broad range of controls for most applications

• ISO, SAE and Cartridge versions

• High overall efficiency throughout the entire displacement range

• The 9-piston design provides high start-up torque and smooth operation

• Small envelop size and a high power-to-weight ratio

• Low noise levels due to a very compact and sturdy design with smooth fluid passages 

• Long service life and proven reliability 

Applications:

• Construction Equipment

• Mining

• Oil & Gas

• Defense

For detailed technical information on V12 motors please download our latest catalogue and installation manuals under Product Support and/or contact your local Parker dealer for support.  

Details regarding the choice of hydraulic fluid     

The correct choice of hydraulic fluid requires knowledge of the operating temperature in relation to the ambient temperature: in

a closed circuit the circuit temperature. The hydraulic fluid should be chosen so that the operating viscosity in the operating temperature range is within the optimum range (νopt) - the shaded area of the selection diagram. We recommended that the higher viscosity class be selected in each case. Example: At an ambient temperature of X °C an operating temperature of 60 °C is set. In the optimum operating viscosity range (νopt; shaded area) this corresponds to the viscosity classes VG 46 or VG 68; to be selected: VG 68. Please note: The case drain temperature, which is affected by pressure and speed, is always higher than the circuit temperature. At no point in the system may the temperature be higher than 115 °C. If the above conditions cannot be maintained due to extreme operating parameters, please consult us.

Hydraulic fluid   

Before starting project planning, please refer to our data sheets RE 90220 (mineral oil), RE 90221 (environmentally acceptable hydraulic fluids) and RE 90223 (HF hydraulic fluids) for detailed information regarding the choice of hydraulic fluid and application conditions. The variable pump A4VG is unsuitable for operation with HFA, HFB and HFC. If HFD or environmentally acceptable hydraulic fluids are being used, the limitations regarding technical data and seals mentioned in RE 90221 and RE 90223 must be observed. When ordering, please indicate the used hydraulic fluid.