High Quality Digital Rotary Encoder with Digital Readout KS800

High Quality Digital Rotary Encoder with Digital Readout KS800

1.Technical characteristic

KS800 is a six-bit displayed table for displaying displacement, which has functons of control, display, transformation, RS485 Protocol, etc.

The high counting frequency is a outstanding feature of KS800, which is up to 500KHZ.

u  International size of 96×48×115mm, six-bit of 0.56 inches nixie tubes.

u  Input A and input B make up two-sides input, which can recognize signal with 90°phase difference from encoder.

u  There are “reset” terminal outside the table, which allows zero data.

u  There are two control values in two relays, it can be used for controling or warning.

u  Standars:Two relays, four kinds of relay output.( There are four relays type for choose).

u  Setting the time of automatical reset-delay to use the funtion of automatical reset-delay.

u  Fuction of displaying peak value.

u  When power off, don’t lose current value and set value.

u  Allows setting resolution.

u  Connected with sensors: power sensors with 5V(100mA),12V(100mA). Accept customized power type.

u  Counting doubling frequency :Quadruple frequency.

u  4-20mA output( Optional).

u  RS485 Protocol.  115200bps communicating baud rate, sending display-value every 5 seconds actively.

2.Technical parameters

u  Supply power: 220VAC 50Hz

u  Input impedance: 5KΩ

u  Pulse frequency: <500KHz

u  Counting magnificaiton: 0.000 ~ 999.999

u  Display-value range: -99999  ~ 999999

u  Level of pulse: Low level: -50V ~ 0.5V    High level: 3.5 ~ 50V

u  Contact capacity: AC250V3A  DC30V3A

u  Installation method: Snap-in type

u  Hole size: 92 × 43.5mm

u  Environment temperature: -10℃~ 50℃

3.Instructions

1>Step1:  Enter into the function of setting parameters.

  Press ”Mo” for more than 2 seconds, the digital table display”Fn00”, and now it turn into the function of setting parameters.

2> Step 2:  Select the parameters we need to set. Take “Fn04” for example.

  Press “ Mo” shortly, the digital table will display “Fn00, Fn001, Fn02, ……., Fn11” in turn.

  When display “Fn004”, press “En” , than come out the original figure of  “Fn04”, with

the last number twinkling.

3>Step 3:   Setting up the selected parameter “Fn04”

  Only the twinkling number can be modified, press “Mo” to select twinkling number, than press “  ↑   “ or “   ↓    “  to rise or lower the twinling numbers. At last, press “En” to completely setup “Fn004”.

4>Step 4:   Setting up other parameters.

   When press “En” in step 3, the digital table is back to step 1, than set other parameters as step 2, step 3.

5>When all the parameter is completely setup, press “ RST” when the digital table display “Fn0xx” , the digital table will be ready to work now.

4.The function of peak value

In condition of working, press“↓”, the pilot lamp “ MAX” will  light up, the display-value will always be peak value.

Press “↓” again, lamp “MAX” will go out, the table will exit the condtion of peak value.

5. Application Show