Drop Forged Wire Rope Clips
By Metalent Corporation - Honest, Professional and Innovative
www.metalentcn.com
1
1
1. Material: Carbon Steel
2. Meet FED. SPEC.: FF-C-450D, TYPE1
3. Surface: Electrolytic zinc plating , Hot dip galvavized
4. Size: 1/8 inch to 2-1/2 inch
5. We could produce nonstandard products according to drawings. Any special needs is welcomed.
1
Step 2. When two clips are required, apply the second clip as near the loop or thimble as possible. Tighten nuts evenly, alternating until reaching the recommended torque. When more than two clips are required, apply the second clip as near the loop or thimble as possible, turn nuts on second clip firmly, but do not tighten. Proceed to Step 3. |
Step 3. When three or more clips are required, space additional clips equally between first two - take up rope slack - tighten nuts on each U-Bolt evenly, alternating from one nut to the other until reaching recommended torque. |
Figure 4. If a pulley (Sheave) is used, in place of a thimble add one additional clip. Clip spacing should be as shown. |
Wire Rope Splicing Procedures: |
Figure 5. The preferred method of splicing two wire ropes together is to use interlocking turnback eyes with himbles, using the recommended number of clips on each eye (See Figure 1). |
Figure 6. An alternate method is to use twice the number of clips as used for a turnback termination. The rope ends are placed parallel to each other, overlapping by twice the turnback amount shown in the application instructions. The minimum number of clips should be installed on each dead end (See |
1
1
Factory:
We are an excellent hardware product processing enterprise. Focus on Hardware Producing over 16 years, supplying high quality hardware products to customers.
Equipment:
Our factory equipped with friction press machines, welding robots, shears, bending machines and a variety of stamping equipment over 100 sets.
Products:
Shackle, Turnbuckle, hook, Wire rope clip, Eye Bolt and Nut, Thimble, Connecting, Link etc.
1
1
1
1
1
1