HT-3D Choke Ring Antenna
3D choke antenna to meet the needs of highprecision measurement equip-ment and multisystem compatibility. Widely used in CORS stations set up, land surveying, seismic monitoring, monitoring of landslides, bridges and other high-precision measurement of deformation monitoring applications.
FEATURE
The antenna part of the multi-point design and fully symmetrical antenna structure, phase center accuracy to millimeter level, and the phase center of high stability, good repeatability;
Using 3D multi-frequency choke coil design, to achieve excellent multi-path suppression effect;
The antenna low elevation gain, high altitude satellite signal tracking ability, to ensure that the system has enough number of satellites;
LNA part of the pre-filter design, effectively suppress the band interference signal, to avoid causing the amplifier saturation, improve system reliability;
Built-in lightning and voltage regulator circuit, the effective protection of the amplifier to ensure that the normal work in harsh environments;
Shell with high reliability of the engineering plastics, using the overall waterproof design, waterproof rating IP67, to ensure that the antenna can work outdoors for many years.
Antenna indicators |
Frequency Range: |
-GPS: L1,L2,L5 |
-GLONASS :L1,L2 |
-Galileo:E1,E5a,E5b,E6 |
-Impedance:50Ω |
Polarization mode:right-handed circular polarization |
The antenna axial ratio:≤2dB |
Horizontal coverage angle:360° |
Output standing wave:≤1.5 |
Antenna gain:≥ |
angle of elevation 90°≥6dBi ; |
angle of elevation30°≥1dBi ; |
angle of elevation 15°≥-3dBi |
Cross polarization ratio:±60 degrees ≥25 |
Phase center error:±1mm |
Environmental |
Working Temperature: -40°C to +85°C |
Storage Temperature: -55°C to +85°C |
Working storage humidity:95% (no condensation) |
Low-noise amplifier index |
Gain:50dB |
Noise figure:≤2dB |
Output standing wave:≤2 |
Anti-burn power:≥6W |
Operating Voltage:3~18VDC |
Operating Current:≤55mA |
Differential transmission delay:≤5ns |
Structural properties |
Size : Φ322×264mm |
Connector Type: TNC-K |
Bottom installation method:5/8"-11UNC |
Weight: 5300g |