(24V 120W power adapter for 24V passive POE PDs, such as for MikroTik and 24V UBNT , 48V 120W power adapter for most IP camera, 802.3af/at WiFi AP. 12V 120W for 12V IP camera with POE splitters for the POE injector.)
As you know, POE injector+normal switch=POE switch, which share the same function, but POE injector+normal switch are more economical.
This gigabit PoE injector panel, whis a simple, cost-saving and convenient equipment for IP camera, IP phone, WiFi Access point, powered onver Ethernet cable.
The gigabit PoE injector panel can power PDs 100 meters far away from power source with safety, low-cost and easy installation.
This gigabit PoE injector is passive PoE but compatible with all IEEE802.3af/at powered devices, while power pins 4/5(V+), 7/8(V-) Mode B and power pins 1,2(V+), 3,6(V-). Because 802.3af/at standards support power pins 4/5V+, 7/8V- and 1/2V+, 3/6V-.
(For most IP cameras, about 6 watts per camera, 8 watts if they have PTZ or IR features. If "12, POE" cameras, it still need 48V Powered Over Ethernet.)
Specification:
POE injector---Adding Gigabit POE function to any Switch/Router/Hub
DC plug input, 12 Lan port, 12 POE port, shielded
For IP camera, IP phone, WiFi, Access point, etc.
19'' 1U Rack-mountable
DC input, 12V 24V 48V 56V
DC output, 12V 24V 48V 56V
10/100/1000Mbps data rate
Over current, over voltage, short-circuit protection.
FCC CE RoHS certified.
LED indicator
Features:
· 12 port Rack-mountable 1U POE Power Injector Panel
· 12 LAN ports, 12 LAN+Power(POE) ports, shielded
· 31 watt max each port, resettable fuse on each port
· Power VOIP phones, IP Cameras, WiFi Access Points, and more PDs
· Same voltage to all ports
· 2.1mm x 5.5mm for DC plug
· LED power light indicator
· Works with any ethernet switch or router, add POE to any switch or router
· Use any power supply to 48 volts, 24 volt, 12 volt, according to your need
· Plastic outside box
Category Pins:
· Pins 1/2 & 3/6 for data and power(Mode A) for CCTV camera, IP phone and 802.3af/at Access Point
· Pins 4/5 & 7/8 for power(Mode B) for MikroTik and 24V UBNT
· Data rate: 100/1000 Mbps TIA/EIA 568B-2
· Connector: RJ-45
· Input Voltage:12V-57V
· Current Output:0.1-0.65A
· Operating Temperature:-40°C~50°C
· Storage Temperature:-40°C~70°C
· Operating Humidity:10%~80%RH
User Manual:
With 24V 120W power supply, Mode B, for 24V passive POE PDs, such as for MikroTik and 24V UBNT.
With 48V 120W power supply, Mode A, for 802.3af/at PDs, such as most IP camera, IP phone and WiFi AP.
With 12V 120W power supply, Mode B, for 12V IP camera, with gigabit POE splitters.
About us:
We are manufacturer of POE produducts and Waterproof RJ45 Connectors.