Add the device to a ZigBee network via coordinator or hub.
1> Please make sure the device not being paired. Otherwise, please "Reset" the device according to the method of "Reset".
2> After step 1, there will be a pairing process about 90s. Once time out, you need to repeat Step 1 again.
3> Open the ZigBee App (Hue or Amazon Alexa) to add the device.
4> If the pairing done successfully after the above steps, the device will blink 3 times.
Touchlink to a ZigBee Remote Control or Touch Panel.
1> Make sure the distance between the device and remote control or touch panel less than 10cm.
2> Method A: Please short press key "Reset" 3 times or power on/off the device 3 times to enter into "Touchlink Commissioning" mode, the device will blink 5 times.
Method B: Re-power on the device, Touchlink Commissioning will start after 15s if not being added to a ZigBee network, 165s time out. Or start immediately if it's already being added to a network, 180s time out. Once time out, repeat the operation again.
3> Set the remote or touch panel to enter "Touchlink Commissioning", please refer to the user manual of the corresponding remote or touch panel.
4> There shall be indication on the remote or touch panel for a successful pairing, the device will blink 2 times. Now the device shall be controllable via the remote or touch panel.