Falling Film Evaporator Lab Evaporator Pilot Test Compact High Efficiency Three effect liquid evaporator

1. The heating system of this system is uniformly heated by steam, and the material liquid is liquid film flow evaporation, so it has the characteristics of high heat transfer efficiency and short heating time.

2. The system is equipped with a hot-pressure pump, and part of the secondary steam is sucked into the shell side of the first-effect evaporator through the hot-pressure pump. The heat is fully utilized, and it has the characteristics of low steam consumption and low cooling water circulation. At the same time, since the steam passing through the heat pressure pump enters the heating shell in the form of spray mist, the steam diffuses rapidly and the material liquid is heated gently, so it is suitable for the concentration of heat sensitive materials.

3. The material is accelerated and pressurized to flow and evaporate along the inner wall of the heating tube, which is suitable for the evaporation and concentration of the material with high viscosity. The heating time of the material liquid is very short, so it is especially suitable for the evaporation and concentration of food, and the nutrients of the food are greatly preserved.

4. The spray feed at the top of the evaporator ensures that the liquid is evenly distributed in the film tube of the evaporator, forming a film, greatly improving the heat transfer coefficient, increasing the evaporation rate, and preventing the "dry wall" phenomenon.

5. The equipment is suitable for the evaporation and concentration of foaming materials. Because the material liquid evaporates in the heating tube as a film, vapor-liquid separation is formed. At the same time, at the bottom of the effect body, most of the material liquid is pumped away, and only a small part of the material liquid and All the secondary steam enters the separator to strengthen the separation, and the material-liquid consolidation process does not cause much impact, and the formation of foam is avoided.

6. If the material needs to be sterilized, the two processes of sterilization and concentration can be completed at one time. The material is preheated, then enters the sterilizer, and then enters the one-effect body. The material flashes quickly and the temperature drops instantly. It is suitable for heat sensitivity. Concentration of feed liquid.

7. The equipment can be equipped with a CIP cleaning system to realize on-site cleaning. The whole set of equipment is easy to operate and has no dead ends.

8. The equipment can be equipped with an automation system to realize automatic control of feed volume, automatic control of heating temperature, automatic control of discharge concentration, automatic control of cleaning, and can also be equipped with protective measures for sensitive materials in the event of sudden power outages and failures. Other automatic operation and control of security and alarm.