Factory wholesales USB temperature data recorder for vaccine and Refrigerated Truckfood cold chain logistics

Small, light, waterproof and in a food safe wrapper, the single used data logger is ideal for monitoring the temperature of shipments in transit. Recordings are started by pressing the start button. The data logger is then placed inside the carton and dispatched. At the receiving end, the data logger is taken from the package and removed from the protective wrapper. It is placed into the USB slot on a computer to get PDF report directly without any software and driver.

Features:
1. Wide measuring range, high accuracy, and large permanent data memory;

2. Over Temperature Alarm & Upper/Lower Limits can be set;

3. MAX/MIN values available;

4. Large permanent data memory of 10000 points;

5. Data could be queried, saved, printed and exported in PDF format, working with PC easily;

6. Single use temperature logger, datalogger, logger data, data logging, data acquisition; 

7. CR2032 button battery works for up to 2 years

8. LED light indicating the different status.

9. no any software installed and driven.

Specifications:
1.Temperature measuring range: -20 °C~+60 °C; Resolution: 0.1°C
2. Accuracy: ±0.5 °C(-20℃~+60℃); others, ±1 ℃

3.Record interval: adjustable

4. Sensor: Internal NTC thermal resistor;

5. Communication interface: USB2.0 interface

6. Power supply: Panasonic battery;
7. Battery life: In normal temperature, if the recording interval sets as 10 minutes, it could be used about 3 months.

8. Water resistant/ Waterproof level: IP67

How to USE:
1. START
Press and hold the button for about 3sec. until the GREEN LED lights
to start logging. If the GREEN LED doesn't light, please don't use this
data logger and users must make sure it's correct to start.
When logging, the GREEN LED will flash once every 10sec. If readings
exceed alarm limit, the RED LED will flash once at the same time to the GREEN LED.

2. PLACE
Put the data logger in the place or specific environment where you want
to monitor and record.

3. STOP
Press and hold the button for about 3sec. until the RED LED lights to
stop logging.
When logging stop or memory full, only RED LED will flash once every 10sec.

4. MARK
Press the button once and the RED LED lights once to indicate one point mark
finished. This device supports up to 6 points mark.

5. GET PDF REPORT
Tear the plastic bag and you can now plug the data logger into an
available USB port on a PC. The RED LED will light when a PDF is
generating. And then the RED and GREEN LED will light when
finished. It may need several seconds (According to logged readings)
to finish. And user should wait until the PC find a U-disk called
“PDF_DATA”, then users can get the PDF report in the U-disk.