Factory price long life automatic bed sheets ironing press machine

1.Single roll

2.multiple rolls

1. There is no special basic requirement for the installation of industrial ironing machine, but the machine must be placed on a relatively flat concrete floor, and the operation position and maintenance position of 1.5 meters are reserved.
2. After the machine is installed, use a level to level the roller.
3. When installing the machine, the inlet and outlet of the steam inlet and the drain pipe should be considered in advance.
4. The machine must be grounded during installation to avoid accidents.

1. Before ironing the fabric, clean the surface of the drum, then wipe the surface of the drum and all parts of the machine with a soft cloth to ensure the machine is clean.
2. The motor and its control part must pass the insulation check to check whether the empty machine is running normally.
3. Check whether the oil holes are unblocked, and inject a proper amount of lubricating oil. Add appropriate amount of oil of 20 or 40 to the reducer.
4. Adjust the conveyor belt to ensure that its tension is moderate and not too tight or too loose.
5. For the steam heating type ironing machine, first open the steam stop valve next to the steam trap, and then open the steam inlet valve later, and then turn off the residual water in the drum; then turn on the speed control motor or the inverter controller. Slowly rotate its knob to run the ironing machine at a low speed of 2~3m/min. At the same time, the inlet valve is fully opened, the roller is heated, and the pressure on the left side of the ironing machine is observed. The steam pressure is above 0.3MPa. You can start ironing work.

6. For the electric heating type ironing machine, first turn on the speed governor or the inverter controller, slowly rotate the knob, run the ironing machine at a low speed of 2~3m/min, then turn on the heating button to heat the roller, and observe that it is located at the ironing machine. The thermometer on the right side of the machine indicates the value, and the temperature can be above 100 °C before ironing can begin.
7. Place the dehydrated fabric on a conveyor belt and iron it into the ironing area.
8. According to the ironing condition of the fabric, the control knob can obtain the appropriate speed and can be ironed normally.

1. Microcomputer control, frequency control, large speed range, very convenient.
2. The chain drive is adopted, the transmission is accurate and reliable, and each transmission roller is a special cold drawn tube to ensure the smoothness of the woven fabric.
3. Smooth operation, low noise and easy operation. The conveyor belt is a special brand that is resistant to high temperatures and static electricity.