Anti- Rust Alkyd Resin Enamel Primer Paint For Aluminium Alloy
FNAH-602 Alkyd Enamel |
|
Color |
All colors |
Thinner |
Alkyd Thinner |
Mixing Ratio |
One-pack |
Shelf Life |
12 months |
Packing Specification |
20 kg/barrel |
2.Product Display:
3.Other Info:
Application Method: |
|||
Airless spray |
Recommended |
||
Nozzle tip |
0.4~0.5mm |
||
Fluid Pressure |
100~150kg/cm² |
||
Thinning |
0~5% |
||
May be applied by airless spray, air spray, brush, or roller. |
|||
Coverage Rate: |
|||
Theoretical |
0.09kg/m2/30μm 0.067 L/m2/30μm |
||
Actual |
Depending on the surface treatment, environment and application methods. |
||
Drying Time: |
|||
Temperature(°C) |
10 |
20 |
30 |
Dry To Touch(hrs) |
1.5 |
1 |
1 |
Dry Hard(hrs) |
12 |
7 |
5 |
Coating Interval: |
|||
Min. |
16 |
10 |
8 |
Max. |
— |
— |
— |
Film Thickness: |
Dry Film Thickness: 30μm /coat Wet Film Thickness: 52μm/coat |
||
Solid Content: |
58% |
||
Specific Gravity: |
1.2 |
4.Characteristics:
¶ Quick drying
¶ Good Gloss
¶ Good Weather Resistance
¶ Good Workability
5.Packaging:
1.Uses:
¶ Used for steel surface.
¶ As topcoat for initial painting of newly-built steel beam, or for re-painting or maintenance of the steel beam in use.
2.Surface Preparation:
¶ The preceding primer surface must be clean, dry and free of contaminants.
¶ Pay attention to the coating interval to the primer.
3.Substrate : Bare steel or old paint film.
4.Primer Coat : Alkyd Primer, or refer to our coating system.
The following shall be guaranteed during any paint applications:
¶ Avoid skin and eye contact.
¶ In case of skin or eye contact, flush with large amount of water and immediately get medical attention.
¶ Assure well-ventilated working place.
¶ Take precautions of the risks of fire or explosion.
¶ Observe all health and safety regulations on site.
¶ The information given on this technical data sheet is correct to the best of our knowledge. In consideration of the application conditions of the product are beyond our control, so no guarantee is involved herein, namely, we are responsible for the buyers only in terms of their selecting a product. All data must be clarified from our company because of the constantly improvement of our product and its manufacturing process.