ESM-NJ06 micro drive torque sensors are suitable mainly used in micro-drive (2Nm hereinafter) measured torque. When the torque measurement is less than 2Nm, rotating body supporting the bearing friction torque it would not be interfering factors ignored. ESM-NJ06 type strain region and take power, emitting region disposed separately, to avoid the impact of the strained region of the bearing, and effectively improve the anti-overload and improve the measurement accuracy of the torque sensor
1.Technical Parameters
Index Name | Specifications |
Range | 0.05Nm,0.1Nm,0.2Nm,0. 5Nm,1Nm,2Nm (optional) |
Power supply | ±15VCD/24VCD(optional) |
Torque signal | 5 ~ 15Khz (amplitude 12V, zero 10kHz), 4 ~ 20mA, 1 ~ 5V, 0-10V (optional) |
Speed Range | 0 ~ 1000,3000,6000,8000 rev / min |
Speed signal | 60 pulses / revolution (no accumulation of errors, the amplitude of 12VDC), 4-20mA, 1 ~ 5V |
Accuracy | ±0.25%,±0.5% |
Stability | 0.3% / year |
Insulation resistance | ≥200MΩ(100VDC) |
Ambient temperature | -20 ~ 60 ℃ (can be customized high temperature -20 ~ 120 ℃) |
Relative humidity | 0~90%RH |
Overload | 120% |
Frequency response | 1ms |
2.Product Feature
ESM-NJ06 micro drive torque sensor is a small-scale way ESM-NJ01 torque sensor: When the range of less than 2N • m, both ends of the supporting bearing friction torque sensors become non-negligible disturbances. ESM-NJ06 torque sensor is structurally different from the torque sensor ESM-NJ01: is to avoid the interference of the bearing friction torques
3.Schematic outline
4.Installation
ESM-NJ06 torque sensor points a. b-side, b-side to measure the end, a b-side to the secondary side coupled through a coupling device under test, when installing additional moment must be avoided.
5.Common signal type and related products
1. Direct torque frequency signal to a computer or PLD processing;
2. The supporting torque indicator, direct display torque value;
3. Supporting series torque speed meter directly display torque, speed and power values
4. Supporting F / I or F / V signal conversion module, the frequency signal is converted to 4-20m A or 1-5V other commonly used analog signals,
Customer convenience signal acquisition.
5. The choice of my company specializing in data acquisition card and the supporting software, torque, speed and other signal acquisition, storage, printing,
Playback functions.
6.Caution
1. Wiring must be correct;
2. ± 15V range: shall not be less than ± 14.5V shall not exceed ± 15.5V;
3. The line output can not be on the ground and power supply short circuit, the output current is less than 10mA;
4. Shielded cable shield must be connected to the common terminal ± 15V power supply (power ground).
5. The sensor elastomer very fine small, strictly limited overload, overload range ≤20%, or vulnerable to damage.
6. use if in doubt please contact the company can not disassemble the warranty period.
Torque sensors are widely used in motors, engines, fans, diesel engines, pumps, valves, oil machinery, testing machines, agricultural machinery, mixing machinery, drillingTorque and rotational speed of machinery and torque measurement device protection applications.