Dual Scoop Coater For Screen Printing

Name:Scoop coater

1.Made of Aluminum 6061 which meets the standard of RoHs 6061

2.Chemical-resistant due to its Oxidation furface.

3.Each side can be used in emuslion coating process with different thcikness

4.Size can be customized according to customer demand, special leak-proof protection settings, and ensure the glue in the best angle.

Screen printing emulsion scoop coater

1.Our Screen printing emulsion scoop coater features a dual sided coating edge for either a sharp edge thin coat for higher screen mesh, or a rounded dull edge for coating lower mesh screens or for coating for heat transfers.

2.Extruded from T6 aluminum this coater is easy to hold, sits easily on flat surface between coats, and holds a good amount of emulsion for lengthy coating sessions.

3.The scoop coater comes complete with snap on injection molded end caps,As well as a full top snap on dust cover.

Features

Easy and comforatable handing

Single-mouth coater,with caps pasted on two end,easy to clean and no leaking

Hold a good amount of emulsion for lengthy coating session

Pre-cut into any size you need :14inch ,16inch ,18inch 20inch etc

Size selection of emulsion coater

The most screens are measured to the outside diameter and there is about 4 inches of screen frame that doesn't need to be coated. For example: A 20x24 inch screen will only require a 16 inch scoop coater:

14 Inch - use for 18" x 20" screens.

16 Inch - use for 20" x 24" screens.

18 Inch - use for 23" x 31" screens.

20 Inch - use for 25" x 36" screens.