Dc digital dual display voltage ammeter Digital display meter 12V 10A 0-100V Voltage and current detection
The parameters are as follows:
Opening size: 45mm*26mm (open the table directly into the panel)
Dimensions: 48mm*29mm*21mm
Power supply voltage :DC3.5-30V (thin red line, positive pole, thin black line, negative pole) Remember that the power supply line cannot overvoltage
Weight: 20g/piece
Display mode: double 3-bit 0.28 inch LED digital tube
Display color: Red + red/red + green
Refresh speed: about 500ms/ time
Measuring accuracy: ±(1% +2 words)
Voltmeter range: DC 0-100V (resolution 0.1V)
Ammeter range: DC 0-9.99A (resolution 0.01a)
Note: When the measured current exceeds 6A for a long time, please directly solder the lead to the socket in case the contact impedance is too high and the line is not stable.
Function description of onboard wire:
Note: If the measured signal is lower than 30V and the power supply is sufficient, it can be directly used as the power supply for the module (use the thin yellow line and thin red line in parallel).
Thin black line (GND) : The negative input pole of the power supply (3.5-30V) shares the ground with the measurement signal
Fine yellow line (VIN) : Measuring signal input positive pole (0-100V)
Thick red line (I+) : current input positive electrode (must be connected to the load negative electrode)
Thick black line (I-) : current input negative electrode (must be connected in series to the supply negative electrode)
Wiring use reminder: the meter can only measure the negative circuit current, that is, the thick black line and thick red line series to the negative circuit can be measured, and pay attention to the position of the thick black line and thick red line, can only measure the one-way current, reverse can not show the current, and such as series to the positive pole will lead to damage to the meter head.
Error phenomenon:
1. Due to the influence of device aging/ambient temperature, the error of small current measurement becomes large
Solution: Short circuit KEY 2 pads when no load, then power on and start up, the module will automatically calibrate the zero point, after the calibration is complete, shut down and disconnect the short circuit point.
2. The linearity of the whole measuring range of the module becomes worse due to the aging of the device/the environmental temperature
Solution: Adjust R7 with load status (best at half range) until the ammeter display value is consistent with a more advanced calibration source
Note: The product may be upgraded and improved sometimes, some components may be changed, and the circuit may be different with different batches. If the product parameters and characteristics are not changed, no other information is required.
Product features:
Perfect function set voltage ammeter in one, the current measurement power supply is taken from the measurement line, do not need isolated power supply for separate power supply, easy to use.
Compact size (48mm*29mm*22mm) believe that has been on the market small volume of voltage ammeter.
Delivery list:
1* voltage ammeter includes enclosure