Customized FRP Outdoor Rectangular Flower Pot and fiberglass Garden Planters by your own design

Fiberglass and resin:

Gel coat: The color is decided by the gel coat,with thickness of about 0.3-0.5mm. UV resistant can be added.

Surface mat:  This is to avoid the air bubble on the surface, and also make fiberglass mat  invisible from the finished surface.

Fiberglass mat: Normally we use 300g/m² (0.6mm thickness) and 450g/m² (0.9mm thickness). Accordig to your requests on the thickness and strength,we will calculate how many layers of fiberglass mat should be used.

Demould and trim:

Solidify:  The time required for solidifying depends on thickness and weather condition.Normally 24 hours for one piece to solidify to avoid any deformation after demoulding.

Demould: After solidified,we will get out the product from the mould

Cut and trim:  We will mark the trim line and hole positions on the mould,then trim according to the marks to gaurantee the mounting dimensions

Air bubble test and repair

Air bubble test: Every piece will be put into the oven under 44 celsius degree for about 20 minutes,so that the air bubbles can break out then our workers will repair the surface.

Repair and surface treatment: we will make the air bubble repaired and treat the surface with average gloss.