| | NXP i.MX6UL-2 CPU,ARM Cortex-A7 kernel, Main Frequency: 528Mhz | | |
| | Single DDR3 SDRAM, standard capacity: 512MB | | |
| | 4GB eMMc(8GB Optional) | | |
| | +5V power input, output all voltages that core board required. | | |
| | 4-CH RS232 serial ports, among which one is debug serial port; 1-CH 5-wire serial port, 2-CH 3-wire serial ports | | |
| | 1-CH USB rapid OTG, 4-CH USB2.0 HOST | | |
| | 2-ch industrial 10/100Mbps Ethernet, RJ45 connector type, with ACT,LINK indictor | | |
| | 1-ch mini PCI-e connector, with SIM card socket, to connect external 3G/4G module | | |
| | 2-ch CAN BUS, isolated, entirely support CAN2.0A and CAN2.0B protocol | | |
| | 1-ch RS485 BUS interface, isolation. | | |
| | 8-ch 12bit ADC | | |
| | 18-bit TFT-LCD, highest resolution ratio: 1366*768 | | |
| | VGA , to connect general displayer. | | |
| | MsASP audio interface, dual-channel output, MIC audio input | | |
| | 4-wire resistive touch screen interface | | |
| | Camera interface, support 8/10/16 bit CSI imaging sensor | | |
| | 1-CH TF card interface | | |
| | Bootup Switch, reset circuit, RTC, Watchdog, buzzer | | |
| | +12V, +5.5V~+28V wide voltage supported. | | |
| | Linux4.1.15 | Electrical Specification | |
| | Baseboard schematic diagram (PDF), PCB, IO comparison table | SOM size | 55mm*46mm |
| | Interface drivers and driver source code | Interface Board size | 185mm*110mm |
| | Interface drivers, test program and source code | Board to Board connector | 2*100pin B to B |
| | gcc-linaro-arm-linux-gnueabihf-4.7-2012.12-20121214_linux.tar.bz2 | Power Consumption | <2W |
| | Uboot | Operation Temperature | -20℃~+70℃, -40℃~+85℃(optional) |
| | QT4.8/5.9 | Humidity | 5%~95%, non-condensing |