CE 37.2cc 3800 Gasoline chain saw tree cutting machine

Product Information

The gasoline engine-powered hand saws are mainly used for logging and building materials. The working principle is based on the staggered L-shaped blades in the saw chain.

Product Details

Power type: Single cylinder,two stroke,air-cooling gasoline engine

Displacement: 37.2cc

Rated output power: 1.2kw

Idling speed: 2800r/min

Two stroke oil/gasoline mixing ration: 01:25

Engine oil tank capacity: 310ml

Fuel tank capacity: 210ml

Guide bar size: 14''/16''

Chain pitch: 0.325"

G.W/N.W: 5KG/4KG

Package: 420x245x280mm

20", 40" , 40"H container                                   1000pcs , 2071 pcs , 3400pcs

1.

Always check the saw chain tension, check and adjust the engine, and wear protective gloves. Tightness is appropriate when the chain is hung in the lower part of the guide, the hand can pull the chain.

2.

There must always be a little oil on the chain. Every time you have to check the saw chain to lubricate and lubricate the oil level of the tank before work. Chain without lubrication absolutely can not work, such as with a dry chain work, will lead to damage to the cutting device.

3.

The chain must be relaxed after work. The chain will shrink during cooling, and no loose chain will damage the crankshaft and the bearing. If the chain is tensioned in the working condition, the chain will shrink when cooled and the chain is too tight to damage the crankshaft and the bearing.

4.

Never use old oil. Old oil can not meet the lubrication requirements and does not apply to chain lubrication.

5.

If the oil level in the tank does not decrease, it may be that the lubrication is faulty. Check the chain lubrication and check the oil path. Through the contaminated filter will also lead to poor supply of lubricants. Clean or replace the oil filter in the tank and pump connection piping.

6.

Replacement After installing the new chain, the saw chain takes 2 to 3 minutes of running time. After running, check the chain tension and re-adjust if necessary. The new chain has been used for some time compared to the chain more often need to tension. In the cold state, the saw chain must be attached to the lower part of the guide plate, but by hand the saw chain can be moved on the upper guide plate. If necessary, re-stretch the chain.